Western Telematic PLS-345 manual Exit/Disconnect, Command Format /X Enter Command Arguments

Page 54

PLS-345 - Physical Layer Switch; User's Guide

/X Exit/Disconnect

Exits from command mode. When you have contacted the PLS via network, the unit will exit command mode and the network connection will be terminated. When you have contacted the PLS via modem, the unit will exit command mode and the modem will hang up. When you have contacted the PLS via a local PC connected to the PLS Console Port, the unit will exit command mode.

Note: When communicating with the PLS, it is recommended to always disconnect using the /X command. If the /X command is not invoked at the end of a command session, then PLS will not exit from command mode until the No Activity Timeout feature closes the session. In this case, further access the PLS command mode will not be allowed until the current session times out.

Command Format: /X [Enter]

Command Arguments:

,y Suppress Confirmation (Sure) Prompt. For example, "/X,y" will cause the PLS to exit the current command mode session without displaying the confirmation prompt.

Response: Displays message indicating that you are about to exit command mode, waits for user confirmation (unless suppressed) and then exits from command mode.

Command Availability: System and User.

10-6

Image 54

Contents PLS-345 Page Nameplate Power Warning Shock Hazard Do Not EnterEnclosed Racks VentilationTable of Contents Command Summary Application ExamplesMonitor Mode IntroductionTypographic Conventions ApplicationsUnit Description Front PanelBack Panel Back PanelUnit Description PLS-345 Physical Layer Switch Users Guide Quick Start / System Overview Modem & Console Port Access Factory set PLS $ telnet 192.168.168.168 EnterCircuit Status Screen Command Help Screen System Mode Installation Power Supply ConnectionInitialization Connecting an External Modem Connecting Common and A/B LinesConnecting the Network Cable Connecting a PC to the Console PortSetUp and Configuration System Mode and User ModeCommunicating with the PLS-345 SetUp and Configuration PLS Command/Menu Conventions SetUp and Configuration Defining General ParametersPLS-345 Physical Layer Switch Users Guide SetUp and Configuration Circuit Parameters Circuit Parameters MenuNetwork Parameters Network Parameters Menu Implementing IP Security IP SecurityExample 1 Deny access to all hosts except Monitor Mode Hardware ConfigurationSelecting Monitor Mode Parameters Monitor Mode Parameters Menu Switch if Level 1 High Switch to Position B Return On Save Configuration Parameters Status Screens Circuit Status ScreenPLS-345 Physical Layer Switch Users Guide Network Status Screen PortPLS-345 Physical Layer Switch Users Guide Manual A/B Switching OperationEnter or /B n Enter Code Activated A/B Switching/A Command and the /B Command Enter/D Command Command Confirmation PromptMonitor Mode Saving and Restoring Configuration Parameters Sending Parameters to a FileRestoring Saved Parameters Monitoring Signal Drop and/or Power Loss Application ExamplesAUX Port Connection Monitoring a Switch or Relay Monitoring a ContactItem 6 Circuits to Switch Enable the Monitor Mode at circuit Display Help Screen Command SummaryDisplay Commands Display Circuit StatusView/Set General Parameters Configuration CommandsSN Display Network Status View/Set Circuit ParametersView/Set Monitor Mode Parameters DL Download Configuration to FileView/Set Network Parameters Control Commands Switch Circuit n to Line aSwitch Circuit n to Line B Command Format /D Enter Command Arguments Set Circuits to DefaultReset Network Interface Command Format /T Enter Command ArgumentsCommand Format /X Enter Command Arguments Exit/DisconnectInterface Descriptions Console Port InterfaceModem Port Interface Common Ports and A/B Ports Figure A.3 Common Ports and A/B PortsSpecifications SwitchingSize Customer Service Trademark and Copyright InformationIndex Index-2 Page Sterling Irvine California 949 586-9950 Toll Free