Western Telematic PLS-345 manual Network Parameters Menu

Page 28

PLS-345 - Physical Layer Switch; User's Guide

NETWORK PARAMETERS:
1.	IP Address:	65.106.93.114
2.	Subnet Mask:	255.255.255.0

3.Gateway Address: 65.106.93.97

4.IP Security

MAC Address:

52-54-40-22-48-7a

Enter Selection or <ESC> to Exit ...

Figure 5.4: The Network Parameters Menu

Note: Although new network port parameters can be specified via a network connection, newly selected parameters will not be applied until your telnet connection to the PLS has been terminated.

1.IP Address: Defines the IP Address for the PLS unit. Type 1, press [Enter] and follow the instructions in the submenu. (Default = 192.168.168.168.)

2.Subnet Mask: Defines the Subnet Mask for the PLS unit. Type 2, press [Enter], and follow the instructions in the submenu. (Default = 255.255.255.0.)

3.Gateway Address: Defines the Gateway Address for the PLS unit. Type 3, press [Enter] and follow the instructions in the submenu. (Default = undefined.)

4.IP Security: Sets up the IP Security feature as described in Section 5.6.1. (Default = undefined.)

5.MAC Address: Displays the unit's MAC address. Note that this item only displays the current address, and cannot be used to redefine the MAC address.

5-10

Image 28

Contents PLS-345 Page Nameplate Power Warning Shock Hazard Do Not EnterEnclosed Racks VentilationTable of Contents Command Summary Application ExamplesMonitor Mode IntroductionTypographic Conventions ApplicationsUnit Description Front PanelBack Panel Back PanelUnit Description PLS-345 Physical Layer Switch Users Guide Quick Start / System Overview Modem & Console Port Access Factory set PLS $ telnet 192.168.168.168 EnterCircuit Status Screen Command Help Screen System Mode Power Supply Connection InstallationInitialization Connecting Common and A/B Lines Connecting the Network CableConnecting an External Modem Connecting a PC to the Console PortSetUp and Configuration System Mode and User ModeCommunicating with the PLS-345 SetUp and Configuration PLS Command/Menu Conventions SetUp and Configuration Defining General ParametersPLS-345 Physical Layer Switch Users Guide SetUp and Configuration Circuit Parameters Circuit Parameters MenuNetwork Parameters Network Parameters Menu Implementing IP Security IP SecurityExample 1 Deny access to all hosts except Hardware Configuration Monitor ModeSelecting Monitor Mode Parameters Monitor Mode Parameters Menu Switch if Level 1 High Switch to Position B Return On Save Configuration Parameters Status Screens Circuit Status ScreenPLS-345 Physical Layer Switch Users Guide Network Status Screen PortPLS-345 Physical Layer Switch Users Guide Manual A/B Switching OperationCode Activated A/B Switching /A Command and the /B CommandEnter or /B n Enter Enter/D Command Command Confirmation PromptMonitor Mode Saving and Restoring Configuration Parameters Sending Parameters to a FileRestoring Saved Parameters Monitoring Signal Drop and/or Power Loss Application ExamplesAUX Port Connection Monitoring a Switch or Relay Monitoring a ContactItem 6 Circuits to Switch Enable the Monitor Mode at circuit Command Summary Display CommandsDisplay Help Screen Display Circuit StatusConfiguration Commands SN Display Network StatusView/Set General Parameters View/Set Circuit ParametersDL Download Configuration to File View/Set Monitor Mode ParametersView/Set Network Parameters Switch Circuit n to Line a Control CommandsSwitch Circuit n to Line B Set Circuits to Default Reset Network InterfaceCommand Format /D Enter Command Arguments Command Format /T Enter Command ArgumentsCommand Format /X Enter Command Arguments Exit/DisconnectConsole Port Interface Interface DescriptionsModem Port Interface Common Ports and A/B Ports Figure A.3 Common Ports and A/B PortsSwitching SpecificationsSize Customer Service Trademark and Copyright InformationIndex Index-2 Page Sterling Irvine California 949 586-9950 Toll Free