Teledyne 2102 Wireless Communication Module Preparation and Installation

Page 21

2102 Wireless Communication Module

Section 3 Preparation and Installation

2.Prepare the Battery Module’s communication connector:

a.Inspect the connector. It should be clean and dry. Dam- aged O-rings must be replaced. Spare O-rings (Tele- dyne Isco P/N 202-1006-69) are supplied in the maintenance kit (60-2099-001).

b.Spray the O-ring’s sealing surface with a silicone lubri- cant.

Note

Do not use petroleum-based lubricants. Petroleum-based lubricants will cause the O-ring to swell and eventually deterio- rate. Aerosol silicone lubricant sprays often use petroleum based propellants. If you are using an aerosol spray, allow a few minutes for the propellant to evaporate before proceeding.

3.Place the carrying handle on the Battery Module. (If you are stacking several modules, it is recommended that you position the handle between the top two modules.)

4.Unlock the Parameter Module’s latch by pressing in on the latch release (right side).

5.Underneath the Parameter Module, remove the cap from the lower communication connector and stow it in the holder.

6.Lock the latch. Locking the latch correctly seats and aligns the lower cap in its holder.

7.Position the Parameter Module over the Battery Module. Align the connectors and lower the Parameter Module onto the Battery Module.

8.Unlock the Parameter Module’s latch by pressing in on the latch release (right side).

9.Firmly press the modules together and lock the Parameter Module’s latch (left side).

The Communications indicator will blink during the start-up routine to indicate the Parameter Module is operating.

Note

Unused communication ports on the top and bottom of the stack must be capped. The connector caps terminate the com- munication lines and protect the pins.

Note

The 2100 System requires Flowlink 4.1or later. Earlier versions do not support 2100 System instruments.

10.To install the 2102 Module, repeat the previous steps used to install the Parameter Module on the battery container.

3-3

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Wireless Communication Module Page Foreword Page Table of Contents Wireless Communication ModuleList of Tables List of FiguresGetting Started Quick Start GuideWireless Module Components Top View Wireless ModuleComponents Item No Description2102 Components Bottom View Wireless Module Components Bottom ViewUpper Connector Capped System Connections Remote unit cable configurations Base unit cable configurationsWireless Module IntroductionOverview Wireless Module Features Applications Controls, Connectors, and IndicatorsTop/Right View Bottom/Left View Controls, Connectors, and Indicators 2102 Module Technical SpecificationsTechnical Specifications 2102 Module Item No Name DescriptionTechnical Specifications 2191 Battery Module Technical Specifications Spread Spectrum RadioPin Name Description Wireless Module Connector PinsPreparation and Installation Preparing for InstallationUnpacking Instructions Wireless Communication Module Preparation and Installation InstallationWireless Communication Module Preparation and Installation Wireless Communication Module Preparation and Installation Testing Installation Wireless Communication Module Preparation and Installation Section Overview ProgrammingRemote Unit Configuration Base Unit ConfigurationBase Module Connect Cables Cable or Power Option Part Number Description Refer to FigWireless Communication Module Programming Maintenance Overview MaintenanceHow to Obtain Service CleaningWireless Communication Module Maintenance Appendix a Replacement Parts Replacement Parts Diagrams and ListingsTeledyne Isco, Inc Wireless Communication Module Appendix a Replacement Parts Fig. A-1 Item No Part Number DescriptionWireless Communication Module Appendix a Replacement Parts Table Hazmat 2100 Nodes 60-2003-550 Rev Page Teledyne Isco One Year
Top Page Image Contents