Tyan Computer B4881V50S4H user manual Replacing the Sata backplane

Page 50

3.5Replacing the SATA backplane

2.Remove all the SATA hot-swap HDD trays from the B4881V50S4H.

3.Remove all cables from the SATA backplane.

4.Remove the two screws holding the cradle locking bar in place and remove the bar.

5.Lift the disk drive cradle to the vertical position as shown. Remove the six screws and lift the backplane from the chassis.

6.Place a new backplane in position and secure in place with six screws.

7.Lower the disk drive cradle into place.

8.Replace the power and data cables.

42	Chapter 3: Replacing pre-installed components

Image 50

Contents B4881V50S4H Page Trademark recognition CopyrightDisclaimer Federal Communications Commission About this manual OverviewSafety information Table of Contents Appendix Overview About the B4881V50S4HFeatures FeaturesUnpacking Box contents Component DescriptionUnpacking Accessories Component DescriptionOpening the box System front view and front panel About the productAbout the product System rear viewSystem internal view Motherboard block diagram HT Connector connect to CPU boardCPU board block diagram FourthFan header locations Tools Before you beginWork area Precautions Before you beginRemoving the chassis cover Installing motherboard componentsInstalling motherboard components Installing CPUs and heatsinks Installing motherboard components Installing memory Position the memory module in the slot Installing CPU expansion board Screws Required Location Installing PCI-X cards Installing hard drivesInstalling hard drives Installing a storage backplane Connect power and data cables to the backplane Installing SATA/SCSI hot swap drives Installing internal hard drives Connect power and data cables to the new drive Rack mounting Rack mountingRack mounting Rack mounting Standalone StandaloneFitting the front door assembly Fitting the front door assemblyFitting the front door assembly Page Introduction Disconnecting all motherboard cablesPower cables Replacing motherboard componentsSata cables CPU fan power cablesReplacing motherboard components IDE cable CD-ROM LED control board cables Replacing motherboard components Floppy disk drive cablesUSB cables Replacing motherboard components LED Control board connector J115 pin out Function Color PinJ119 ID Switch and J118 LED Replacing the CPU expansion board Replacing the motherboard Replacing the slim CD-ROM driveReplacing the slim CD-ROM drive Replacing the slim CD-ROM drive Replacing the floppy disk drive Replacing the floppy disk driveReplacing the Sata backplane Replacing the Sata backplaneReplacing the Sata backplane Replacing cooling fans Replacing power suppliesReplacing power supplies Replacing cooling fans PhoenixBIOS Setup Utility Hardware monitor submenuFeature Option Description Integrated devices submenuRemote access configuration submenu DirectHelp resources Returning merchandise for serviceTechnical support