2.5 Standalone
2.5Standalone
The B4881V50S4H can be used as a standalone device when fitted with the plastic feet in the accessory pack. When used as a standalone device, the feet must be fitted to pre- vent the unit from falling over.
The four feet should be attached as follows:
1.Each foot consists of two pieces. Insert the round piece of the foot into the other foot section. The small plastic tab on the round piece should fit into the curved slot on the other piece.
Curved slot
Tab fits in curved slot
2.Use a single screw through the center of the round sec- tion to fasten the foot assembly to the bottom of the chas- sis. The plastic tab that protrudes through the curved slot should fit into an indent in the chassis case.
When fitted, each foot should rotate about 90°.
3. Fit all four feet in the same way.
Chapter 2: Setting up | 29 |