VXI EX7000 user manual Device Identify, Upgrade

Page 33

www.vxitech.com

NOTE	Specifying SNTP or NTP servers by hostname requires that the instrument be configured for DNS,
	either by DHCP or Static IP.

DEVICE IDENTIFY

This action page is used to identify the EX7000 that is being commanded in the current session. When the “Turn on” button is pressed, the LAN LED located on the rear panel of the EX7000 will blink. When the “Turn off” button is pressed, the LAN LED returns to its normal operation.

FIGURE 4-9: DEVICE IDENTIFY WEB PAGE

UPGRADE

	This action page is used to upgrade the embedded firmware of the EX7000. Prior to initiating the
	firmware upgrade process, a new, uncompressed firmware image must be obtained from
	VXI Technology and be accessible from the computer that is connected to the EX7000. Unless
	specifically noted by VXI Technology, firmware upgrades do not alter the non-volatile
	configuration settings (network configuration, time configuration) of the EX7000.

NOTE	Do not power cycle the EX7000 during the firmware upgrade process. If power is lost during the
	upgrade, the instrument may be put into an inoperable state, requiring return to the factory. An
	uninterruptible power supply may be used to avoid this risk.

EX7000 Series Web Page Operation

33

Image 33

Contents EX7000 Series VXI Technology, Inc EX7000 Series Preface Table of Contents Index SectionLimitation of Warranty WarrantyCertification Restricted Rights LegendSteve Mauga, QA Manager EMCTerms and Symbols Service should only be performed by qualified personnelSupport Resources Introduction SectionEX7400 LXI Based Custom RF Interface Platform Common FeaturesPopulated EX7400 Mainframe Interactive Control4JAVA-BASED Graphical User Interface Relay Drive ControlRelay Odometer Configuration TableExclude Lists Scan ListsEX72SF EX7000 SpecificationsInstallation Location OverviewUnpacking Driver Installation EX7000 Hardware SetupNetwork Configuration MAC Address AutoIP Default Address VXI Technology, Inc EX7000 Series Preparation for Use EX7000 Typical Rear Panel View EX7400 Rear Panel ViewDigital I/O Connector Trigger Bus ConnectorsGeneral Purpose I/O Characteristic ValueFront Panel View Reset ButtonEX72SF EX7400 General WEB page Operation WEB page OperationEX7000 Main WEB Password ProtectionEX7000 Title Block VXI Technology LogoEX7000 Soft Front Panel Soft Front PanelA pseudorandom fashion until it finds one that is available Dhcp or static IP configurations EX7000 Time Configuration WEB page Manual Time ConfigurationTime Configuration WEB page Sntp Device Identify UpgradeReboot ResetSystem Overview Theory of OperationOPEN-COLLECTOR VS. TTL Drive Lines Relay Drive Connector BanksContinuous Mode Relay Access & ControlContinuous Operation Mode Pulse ModeIndex