Operations Common to Each Mode

To change adjustment setting

1.Press and hold the [DISP] button (1 sec.) to switch to the adjustment selection display.

2.Press the [x] or [v] button to select the “item name”.

“CLOCK” ↔ “CONTRAST” ↔

“SETTINGS” ↔ “SCRN SVR” ↔

“MESSAGE INPUT” ↔ “SCROLL” ↔ “DIMMER” ↔ “BLINKLED” ↔ “A-CANCEL” ↔ “SYSTEM CHECK”

3.Press the [] or [] button to select the “desired setting value”.

∗In the case of display blinking “ENT”, you can press the [ ] button to adjust the setting value.

∗After completing settings, press the [DISP] button to return to the previous mode.

●Setting the clock

2-1. Select “CLOCK”.

3-1.	Press the [	] button.
3-2.	Press the [x] or [v] button to select the
	hour or the minute.
3-3.	Press the [	] or [ ] button to set the
	correct time.
	∗ The clock is displayed in 12-hour format.
3-4.	Press the [	] button to store the time into
	memory.

Note:

•You cannot set the clock when it is displayed with only the ignition on. If you drain or remove the car’s battery or take out this unit, the clock is reset. While setting the clock, if another button or operation is selected, the clock set mode is canceled.

●Setting the contrast

You can adjust the display contrast to match the angle of installation of the unit.

∗The factory default setting is “10”. (Adjustment level: 1 to 16)

2-1. Select “CONTRAST”.

3-1. Press the [] or [] button to adjust the contrast.

●Displaying the settings

The number of indicator of this unit decreases, you can see the state of current settings at any operation mode.

2-1. Select “SETTINGS”.

3-1. Press the [] or [] button to display the state of current settings.

∗When the setting is selected, after 1 second the current state will be displayed.

For example:

after 1 second,

●Turning the screen saver function on

or off

This unit is provided with the screen saver

function which allows you to show various kinds of patterns and characters in the operation status indication area of the display in a random order. You can turn on or off this function. If the button operation is performed with the screen saver function on, the operation display corresponding to the button operation is shown for about 30 seconds and the display returns to the screen saver display.

∗The factory default setting is “ON”.

2-1. Select “SCRN SVR”.