English Owner’s Guide
The operation panel turns upward and down- ward several times and stops at the stored angle.
5)Press the ADJ button 10 to return to the pre- vious mode.
*If you want to change the stored angle, per- form the same operation from step 1).
Notes:
•In step 3) above, the operation panel turns upward and downward several times to store the set angle. During this operation, be careful not to let your fingers get caught in the panel.
•Under some operating conditions, the stored angle may vary slightly.
•If you press the Close button 28 when the opera- tion panel is turned downward (tape is ejected), the panel will not be set to the stored angle.
Setting the clock
1)Press the ADJ button 10 to go to the CON- FIGURATION display.
2)Slide the Up/Down button 11 to 
(down) or 
(up) and move the cursor to “CLOCK.”
3)Press 
(center) of the ENT button 11 to go to clock setting mode.
4)Slide the Up/Down button 11 to 
(left), 
(right), 
(up), or 
(down) to set a time.
Increments the figure.
Selects the hour. 
Selects the minute.
Decrements the figure.
: Selects the hour (the hour becomes blue and can be changed).
: Selects the minute (the minute becomes blue and can be changed).
: The hour or minute increments while the corresponding figure is blue.
: The hour or minute decrements while the corresponding figure is blue.
5)After adjusting the time, press 
(center) of the ENT button 11 to set it.
*Pressing 
(center) of the ENT button 11 resets the second to zero.
6)Pressing the ADJ button 10 returns the mode to the previous one.
Note:
•The time is always displayed in radio, tape, CD, and CD changer modes. (However, when the “CITY LIGHTS” pattern in the spectrum analyzer is selected or the security camera is used, the time is not displayed.)
16