9. OPERATION
Basic Operations | Note: Be sure to read this chapter referring to the front diagrams of |
chapter “2. CONTROLS” on page 5 (spread). |
English
CAUTION
When this unit is turned on, starting and stop- ping the engine of a car with its volume raised to the maximum level may harm your hearing. Be careful about adjusting the volume.
CAUTION
: Decreases the volume.
*The volume level indicated is in the display in a range from 0 (minimum) to 33 (maximum).
Note:
Owner’s Guide
NOTE: Use this unit after starting the engine. | • In the CONFIGURATION or BALANCE display, |
| the volume cannot be adjusted. |
ACC or engine
ON position
Turning on the power and adjusting the volume
1)After turning the car’s ignition switch on and starting the engine, press the FUNC button 12 to turn on the power to the unit.
*The current mode is shown in Display 27 .
*This unit starts in the mode it was in when the power was turned off last.
2)Press the FUNC button 12 to select the oper- ation mode.
Each time you press the FUNC button 12 , the operation mode changes as follows:
Radio mode
CD changer mode Tape mode (When the CD changer is connected)
CD mode
WARNING
THIS PRODUCT IS NOT INTENDED FOR VIEWING TELEVISION BROADCASTS OR VIDEO TAPES OR FOR PLAYING VIDEO GAMES. Such uses of this product may distract the driver or interfere with the dri- ver’s safe operation of the motor vehicle and may violate state law. CLARION DIS-
CLAIMS ANY LIABILITY FOR ANY BODILY INJURY, INCLUDING FATALITIES, OR PROPERTY DAMAGE THAT MAY RESULT FROM ANY SUCH UNINTENDED USES OR FROM ANY IMPROPER USE OF THIS PRODUCT.
*Press and hold the FUNC button 1 second to turn off the power.
3)Slide the Up/Down button 11 to
(down) to adjust the
volume.
: Increases the volume.
12for about
(up) or
14