Omega 1002 manual Jumper Settings

Page 23

2.7 Jumper Settings

There is only one jumper on the OME-PCI-1002. JP1 is used to select the analog input type. For single-ended inputs, users should connect Pin-1, 3 and Pin-2, 4. For differential inputs, Pin-3, 5 and Pin-4, 6 should be connected.

JP1JP1

1	2	1
		1
5	6	5
	Single-ended	Differential
Inputs (Default)		Inputs

Image 23

Contents User’sGuide Servicing North America Table of Contents Software and Demo Program Diagnostic Program General Description IntroductionX86 System Block DiagramFeatures Analog Inputs SpecificationsPower Consumption 4 A/D Trigger Methods 3 D/I and D/OInterrupt Channel Programmable Timer/CounterOME-PCI-1002 series multifunction cards ApplicationsRelease Notes Product Check ListBoard Layout Hardware ConfigurationA/D Calibration Jumper SettingOME-PCI-1002 System Function Block System Block DiagramOME-DB-8225 OME-DB-37 Daughter BoardsOME-DB-16P Isolated Input Board OME-DB-16R Relay Board Analog Input Signal Connection Page Page Signal Shielding Jumper Settings Connectors Page O Registers How to Find the I/O AddressPage I/O Address Map Section 8254 Registers Status Register Clear Interrupt Interrupt Source Selection General Control RegisterTrigger Method Selection Digital I/O Function OperationA/D trigger 8254 TimerSymbol Name Minimum Maximum CPU A/D ConversionSuggested Settling Times 1 A/D Conversion Trigger Modes Software Trigger and Polling Techniques Page Page Software and Demo Program Driver Plug & Play Test Power-ON Plug & Play TestA/D Test D I/O TestWARRANTY/DISCLAIMER Temperature