Omega 1002 manual Interrupt Channel, Programmable Timer/Counter

Page 10

1.4.5 Interrupt Channel

• Interrupt:

INTA (Automatically assigned by PCI-controller).

•Enable/Disable: Via PCI control register and add-on control register.

•Interrupt source: (Selected by on-board control register)

1.A/D conversion interrupt

2.Pacer 0 interrupt (Timer 0)

3.Pacer 1 interrupt (Timer 1)

4.External interrupt

1.End of Conversion

A/D busy

IRQ

3.
		Falling edge of Pacer 1

	Pacer 1

IRQ

2.

Pacer 0

IRQ

4.

External

Trigger

IRQ

Falling edge of Pacer 0

Falling edge of

External trigger

Figure 1-3. Programmable interrupt source.

1.4.6 Programmable Timer/Counter

•Type: 82C54-8 programmable timer/counter.

•Timers:

1.Timer 0 for Pacer trigger and interrupt

2.Timer 1 for External trigger and interrupt

3.Timer 2 for software machine independent timer

•Input Clock: 4 MHz.

10

Image 10

Contents User’sGuide Servicing North America Table of Contents Software and Demo Program Diagnostic Program Introduction General DescriptionBlock Diagram X86 SystemFeatures Power Consumption SpecificationsAnalog Inputs 3 D/I and D/O 4 A/D Trigger MethodsProgrammable Timer/Counter Interrupt ChannelApplications OME-PCI-1002 series multifunction cardsProduct Check List Release NotesHardware Configuration Board LayoutJumper Setting A/D CalibrationSystem Block Diagram OME-PCI-1002 System Function BlockDaughter Boards OME-DB-8225 OME-DB-37OME-DB-16P Isolated Input Board OME-DB-16R Relay Board Analog Input Signal Connection Page Page Signal Shielding Jumper Settings Connectors Page How to Find the I/O Address O RegistersPage I/O Address Map Section 8254 Registers Status Register Clear Interrupt General Control Register Interrupt Source SelectionTrigger Method Selection Function Operation Digital I/O8254 Timer A/D triggerSymbol Name Minimum Maximum A/D Conversion CPUSuggested Settling Times 1 A/D Conversion Trigger Modes Software Trigger and Polling Techniques Page Page Software and Demo Program Power-ON Plug & Play Test Driver Plug & Play TestD I/O Test A/D TestWARRANTY/DISCLAIMER Temperature