Omega 1002 manual Software and Demo Program

Page 44

5. Software and Demo Program

1. Demo programs for DOS
•	…\1002\BC\LARGE\DEMO>	← demo program
•	…\1002\BC\LARGE\LIB>	←library and driver

•DEMO1: Digital output.

•DEMO2: Digital output and Digital input test by itself.

•DEMO3: A/D Polling for channel 0.

•DEMO4: A/D Polling for channel 0,1,2,3 and defferent gain 1,2,4,8.

•DEMO5: A/D Pacer trigger.

•DEMO6: A/D Calibration.

•DEMO7: Find card number.

2.Demo program for Windows95/98/NT

• Refer to CD-ROM.

44

Image 44

Contents User’sGuide Servicing North America Table of Contents Software and Demo Program Diagnostic Program Introduction General DescriptionBlock Diagram X86 SystemFeatures Analog Inputs SpecificationsPower Consumption 3 D/I and D/O 4 A/D Trigger MethodsProgrammable Timer/Counter Interrupt ChannelApplications OME-PCI-1002 series multifunction cardsProduct Check List Release NotesHardware Configuration Board LayoutJumper Setting A/D CalibrationSystem Block Diagram OME-PCI-1002 System Function BlockDaughter Boards OME-DB-8225 OME-DB-37OME-DB-16P Isolated Input Board OME-DB-16R Relay Board Analog Input Signal Connection Page Page Signal Shielding Jumper Settings Connectors Page How to Find the I/O Address O RegistersPage I/O Address Map Section 8254 Registers Status Register Clear Interrupt General Control Register Interrupt Source SelectionTrigger Method Selection Function Operation Digital I/O8254 Timer A/D triggerSymbol Name Minimum Maximum A/D Conversion CPUSuggested Settling Times 1 A/D Conversion Trigger Modes Software Trigger and Polling Techniques Page Page Software and Demo Program Power-ON Plug & Play Test Driver Plug & Play TestD I/O Test A/D TestWARRANTY/DISCLAIMER Temperature