Omega 1002 manual D I/O Test, A/D Test

Page 46

cards.

Step 7: If a card’s D/O=D/I Æ this is the physical card number, remember this number.

Step 8: Repeat the previous two steps to find the physical card number of all boards.

6.3 D I/O Test

Step 1: Power-off the PC.

Step 2: Install one OME-PCI-1002 card with a 20-pin flat cable between CON1 & CON2.

Step 3: Power-on the PC then run DEMO2.EXE.

Step 4: The DO and DI are displayed as TEST OK or TEST ERROR.

6.4 A/D Test

•A/D Test for OME-PCI-1002 card Step 1: Power-off the PC.

Step 2: Install one OME-PCI-1002 card.

Step 3: Power-on PC, run DEMO6.EXE

Step 4: Apply +10V to channel 0.

Step 5: Apply +0V to channel 1.

Step 6: Apply -10V to channel 2.

Step 7: Run DEMO6.EXE.

Step 8: Check channel 0 = fff or ffe?

Step 9: Check channel 1 = 800 or 801?

Step 10: Check channel 2 = 000 or 001?

46

Image 46

Contents User’sGuide Servicing North America Table of Contents Software and Demo Program Diagnostic Program Introduction General DescriptionBlock Diagram X86 SystemFeatures Power Consumption SpecificationsAnalog Inputs 3 D/I and D/O 4 A/D Trigger MethodsProgrammable Timer/Counter Interrupt ChannelApplications OME-PCI-1002 series multifunction cardsProduct Check List Release NotesHardware Configuration Board LayoutJumper Setting A/D CalibrationSystem Block Diagram OME-PCI-1002 System Function BlockDaughter Boards OME-DB-8225 OME-DB-37OME-DB-16P Isolated Input Board OME-DB-16R Relay Board Analog Input Signal Connection Page Page Signal Shielding Jumper Settings Connectors Page How to Find the I/O Address O RegistersPage I/O Address Map Section 8254 Registers Status Register Clear Interrupt General Control Register Interrupt Source SelectionTrigger Method Selection Function Operation Digital I/O8254 Timer A/D triggerSymbol Name Minimum Maximum A/D Conversion CPUSuggested Settling Times 1 A/D Conversion Trigger Modes Software Trigger and Polling Techniques Page Page Software and Demo Program Power-ON Plug & Play Test Driver Plug & Play TestD I/O Test A/D TestWARRANTY/DISCLAIMER Temperature