Power Up and Basic Parameter Setup |
Start Up Procedure
START
Installation
Wiring
Set power supply voltage jumper *1
Turn ON power
Confirm status
Select control
method.
Basic settings
(Quick programming mode)
Settings according
to control mode
NO | Vector Control |
| |
V/f control |
| ||
|
|
| |
YES |
|
|
|
YES | V/f Control with PG |
|
|
PG? |
|
| |
|
|
| |
NO |
|
|
|
V/f control |
|
|
|
Set | Set | *2 |
|
V/f default: 200V/50Hz (400V/50Hz) | V/f default: 200V/50Hz (400V/50Hz) |
| |
|
| Motor |
|
|
| operation possible | NO |
|
| during autotuning? |
|
|
| *3 |
|
|
| YES |
|
*4 | Rotating | *6 | ||
for |
| autotuning |
| autotuning |
Application settings
(Advanced programming mode)
operation
Loaded
operation
Optimum adjustments and parameter settings
Check/record
parameter settings
END
1.Set for 400 V Class Inverter for 75 kW or more.
2.If there is a reduction gear between the motor and PG, set the reduction ratio in
3.Use rotational autotuning to increase autotuning accuracy whenever it is okay for the motor to be operated.
4.If the motor cable changes to 50 m or longer for the actual installation, perform
5.The default control mode is Open Loop Vector control
6.If the maximum output frequency and the base frequency are different, set the maximum output frequency
Fig 8 Trial Operation Flowchart