PART 7
APPROVALS INFORMATION
7.1CE APPROVALS INFORMATION
This product conforms to the EMC directive 89/336/EEC amended by 93/68/EEC, and with the European Low Voltage Directive 72/23/EEC.
Electrical Safety
Safety requirements for electrical equipment for measurement, control and laboratory.
Double Insulation |
| |
Pollution Degree 2 |
| |
Dielectric withstand Test per 1 min |
| |
• | Power to Input/Output: | 2300Vac (3250Vdc) |
• | Power to Input/Output: | 1500Vac (2120Vdc) |
|
| (Low Voltage dc Power Option*) |
• | Power to Relays/SSR Output: | 2300Vac (3250Vdc) |
• | Ethernet to Inputs: | 1500Vac (2120Vdc) |
• | Isolated RS232 to Inputs: | 500Vac (720Vdc) |
• | Isolated Analog to Inputs: | 500Vac (720Vdc) |
• | Analog/Pulse to Inputs: | No Isolation |
Measurement Category I
Category I are measurements performed on circuits not directly connected to the Mains Supply (power). Maximum
Transients Overvoltage Surge (1.2 / 50uS pulse)
• | Input Power: | 2500V |
• | Input Power: | 1500V |
|
| (Low Voltage dc Power Option*) |
• | Ethernet: | 1500V |
• | Input/Output Signals: | 500V |
Note: *Units configured for external low power dc voltage,
EMC EN61326:1997 + and A1:1998 + A2:2001
Immunity and Emissions requirements for electrical equipment for measurement, control and laboratory.
•EMC Emissions Table 4, Class B of EN61326
•EMC Immunity** Table 1 of EN61326
Note: **I/O signal and control lines require shielded cables and these cables must be located on conductive cable trays or in conduits. Furthermore, the length of these cables should not exceed 30 meters
Refer to the EMC and Safety installation considerations (Guidelines) of this manual for additional information.
7.2FCC
This device complies with Part 15, Subpart B, Class B of the FCC rules.
43