Omega Speaker Systems HX93DA Temperature Display Scaling Recommended equipment, For ºF Display

Page 16

15A

HX93A, HX93DA SERIES

RH/Temperature Transmitter

 

 

 

Temperature Display Scaling

Recommended equipment:

RTD Simulator OMEGA® Model No.: CL510-1

Handheld Digital Multi-meter, OMEGA® Model No.: HHM29

Dc Power Supply, OMEGA® Model No.: PSU-93

For ºF Display

1.Remove enclosure cover

2.Connect the power supply and multimeter as shown in the figure 7.

3.Disconnect the 2-wire Connector "J4" from the main Board.

4.Connect the RTD simulator to the "J4" header on the main board as shown below.

5.Apply power to transmitter and allow to warm up for 10 min.

6.Set the RTD simulator for 0ºF output. (See figure on page 11.)

7.Adjust potentiometer "ZERO" on the back of the Temp display for a reading of 0.0ºF

8.Set the RTD simulator for 150ºF output.

9.Adjust potentiometer "GAIN" on the back of the RH display for a reading of 150.0ºF

10.Repeat steps 6, 7, 8 and 9 as necessary until proper readings are maintained.

11.Calibration complete.

For ºC Display

12.Remove enclosure cover

13.Connect the power supply and multimeter as shown in the figure 7.

14.Disconnect the 2-wire Connector "J4" from the main Board.

15.Connect the RTD simulator to the "J4" header on the main board as shown below.

16.Apply power to transmitter and allow to warm up for 10 min.

17.Set the RTD simulator for 0ºC output. (See figure on page 11.)

18.Adjust potentiometer "ZERO" on the back of the Temp display for a reading of 0.0ºC

19.Set the RTD simulator to the 150ºC output.

20.Adjust potentiometer "GAIN" on the back of the RH display for a reading of 150.0ºF

21.Repeat steps 6, 7, 8 and 9 as necessary until proper readings are maintained.

Calibration complete.

12

Image 16
Contents User’sGuide For immediate technical or application assistance Servicing North AmericaServicing Europe HX93A, HX93DA Series SectionRM/Temperature Transmitter HX93A, HX93DA SeriesRH/Temperature Transmitter General DescriptionUnpacking Additional Transmitter Models Available DescriptionTheory of Operation Example When using a 24 Vdc power supplyFor HX93A For HX93DA Mounting Recommended AccessoriesComplimentary Instruments Current Transmitter Wiring Examples Electrical ConnectionsVoltage Transmitter Wiring Examples Relative Humidity Output CalculationsTemperature Output Calculations RH Measured Vs Output ReadingFor Current output in ºC -20 to 75ºC Vdc ÷ .005848 4 = 81.5ºFCalibration Procedure for HX93AC all styles Relative Humidity AdjustmentCalibration Recommended equipmentTemperature Adjustment HX93AC Calibration Procedure Temperature AdjustmentCalibration Procedure for HX93AV all styles HX93AV Calibration Procedure Relative Humidity AdjustmentHX93AV Calibration Procedure Temperature Adjustment 15A. Display Scaling for HX93DAC all styles Relative Humidity Display Scaling Recommended equipmentFor ºF Display Temperature Display Scaling Recommended equipmentFor ºC Display Maintenance SpecificationsTemperature Relative HumidityGeneral Specifications DimensionsWeight Wall Mount Model Duct Mount Model Sensor Type Ohm Platinum RTWARRANTY/DISCLAIMER Temperature