3.4.5.4Updating the NMM Firmware via FTP
Using an FTP application, upload the new firmware into the FTP root directory of the NMM. When the file transfer is complete, the NMM verifies the file and then automatically restarts with the newly loaded firmware.
For detailed instructions on updating the management modules and other modules in the same chassis via FTP, download the application note “iConverter Management: Updating Modules via FTP” available on Omnitron’s web page:
See Setting NMM Passwords, Section 3.4.1.4, on how to configure FTP.
3.5VERIFY OPERATION
Once the module has been installed and configured, per Sections 3.2 - 3.4, verify the module is operational by viewing the status of the LED indicators. The table below provides a description for each indicator.
The Power LED indicates the module is receiving power from the chassis. The NMM has an LED indicator for each available power supply in the chassis
The Master/Slave and Management LEDs indicate the operation and configuration of the management channel. A blinking “Mgt” LED indicates the NMM is polling the chassis.
The UTP “Lk/Rx” LED indicates the module has established a connection across its UTP port. A blinking LED indicates the presence of data.
Refer to Section 6.0, Troubleshooting Guide, for help in determining possible fault conditions.
LED Function | Color | Off State | On / Blinking State | |
"Legend" |
|
|
| |
Power "Pwr" | Amber | No power | Module has power | |
|
|
|
| |
Power Supply |
| Power Supply #1 not | On: Power available from installed Power | |
| Supply #1 | |||
#1 Status | Amber | |||
installed | Blinking: No power available from installed | |||
"PS1" |
|
| Power Supply #1 | |
|
|
| ||
Power Supply |
| Power Supply #2 not | On: Power available from installed Power | |
| Supply #2 | |||
#2 Status | Amber | |||
"PS2" |
| installed | Blinking: No power available from installed | |
|
| Power Supply #2 | ||
|
|
| ||
Power Supply |
| Power Supply #3 not | On: Power available from installed Power | |
| Supply #3 | |||
#3 Status | Amber | |||
installed | Blinking: No power available from installed | |||
"PS3" |
|
| Power Supply #3 | |
|
|
| ||
|
| Network Ports Status | ||
|
|
|
| |
Management | Green | Slave Mode | Master Mode | |
Mode "Msr/Slv" | ||||
|
|
|
| |
Management | Green | No Polling Activity | Management Polling Activity | |
Polling "Mgt" | ||||
|
|
| ||
|
|
|
| |
Management |
|
| On: 10Mbps UTP Port Link is active (via | |
Port Link and | Green | No Link | either UTP or Backplane Port A) | |
Activity "Lk/Rx" |
|
| Blinking: UTP Port Data Activity | |
Page 20