Passwords

3.4CONFIGURE THE MODULE VIA COMMAND LINE INTERFACE

To configure, attach the NMM to a DB-9 serial (RS-232) equipped computer with terminal emulation software such as HyperTerminal. Using a standard serial cable, connect the serial port of the PC and the Serial Console Port of the NMM. This is a standard asynchronous DCE serial interface. The pin-outs are illustrated below.

		DB-9 Female
RD	2	5	1
TD	3	5	1
TD	3
GND	5	9	6
RTS	7	9	6
RTS	7

Serial Connector Pin Outs

Start HyperTerminal and select the correct COM Port in the HyperTerminal “Connect To:” window. Set the PC’s serial port to the following:

Bits Per Second:	57,600
Stop Bits:	1
Data Bits:	8
Parity:	NONE
Hardware Flow Control:	NONE

Power the chassis containing the NMM and press <ENTER> to bring up a command line prompt on the attached PC.

The module is configured with the following defaults:

IP
IP Address:	192.168.1.220
IP Subnet Mask:	255.255.255.0
Passwords
Serial:	No password assigned
FTP:	No password assigned
Telnet:	public

SNMPv1/v2c Communities

READ:	public
WRITE:	public
SNMPv3 Parameters
User 1 name (read only):	guest
User 2 name (read/write):	admin
User 1 Privacy pwd:	publicguest	User 1 Authen pwd:	publicguest
User 2 Privacy pwd:	privateadmin	User 2 Authen pwd:	privateadmin

Page 9

SNMPv3 Parameters