Omnitron Systems Technology 8000-0 user manual UTP Management Port

Page 5

The illustration below shows how multi-chassis are managed using Omnitron’s NetOutlook Management Software. From the chassis view screen, each of the chassis are available.

NetOutlook Chassis View

Multi-chassis configuration can also be managed through the serial console port. From the Chassis Selection section of screen, each of the chassis connected together are available. See Section 4.0 for detailed menu screens.

2.1.3UTP Management Port

The NMM features a front-panel 10Mbps Ethernet management port to facilitate SNMP management of iConverter modules in a 2, 5 or 19-Module chassis. Front-panel (Out-of-Band) management is accomplished by attaching a Category 5 UTP or better cable to the Ethernet front-panel management port.

2.1.4Ethernet Backplane Port

The NMM also features a 10Mbps Ethernet backplane port. The backplane port A allows Ethernet data connectivity between the adjacent module in the chassis. The backplane port provides In-Band management connectivity between the NMM and the adjacent module when both have their backplanes enabled. Management traffic from the adjacent module transverse the backplane to the NMM.

The backplane port can be disabled or enabled via an on-board slide switch. The NMM supports Backplane Port A only.

Page 5

Image 5
Contents IConverter Network Management Module Table of Contents Overview Port Structure UTP Management Port B B B B B B B Out-of-Band Management Installation Procedure Passwords Management Options screen will be displayed Setting IP and Control Preferences Setting IP Parameters as Dhcp Client Setting NMM Passwords Setting Snmp Preferences Setting the Snmp Trap IP Host Addresses Vlan ID NMM Access the NMM Remotely Updating the NMM Firmware via the Serial Console Port Verify Operation NMM Module StatusLED NMM Specifications Possible Causes Troubleshooting GuideLimitation of Warranty Warranty