Omnitron Systems Technology 8000-0 user manual Installation Procedure

Page 8

3.0INSTALLATION PROCEDURE

3.1OVERVIEW

The following steps outline the installation and configuration procedures for the NMM. Refer to the specified sections for detailed instructions.

•Configuring Switches (Section 3.2)

•Installing the Module and Connecting the UTP Cable (Section 3.3)

•Configure the Module via Command Line Interface (Section 3.4)

•Verify Operation (Section 3.5)

When the setup and configuration procedures are completed, the NMM has been configured for operation.

3.2CONFIGURING SWITCHES

Board Mounted Switches

3.2.1Ethernet Crossover Switch

The NMM has an on-board switch for the configuration of the device connecting to the front-panel UTP management port. When connecting to a hub or switch, set the Ethernet Crossover Switch to “Switch”. When connecting to a workstation, set to “Workstation” (factory default).

3.2.2Backplane Enable Switch

The NMM provides an on-board switch to configure the module for In-Band or Out-of-Band management. When the Backplane Enable Switch is in the Front position (factory default), the front-panel UTP management port is enabled and the backplane Ethernet port is disabled. This is defined as Out-of-Band management. When the switch is in the Back position, the front-panel port is disabled and the backplane port is enabled. This is defined as In-Band management. In this setting, the NMM module can communicate with an adjacent module via the chassis backplane.

3.3INSTALLING THE MODULE AND CONNECTING THE UTP CABLE

•Since the NMM only supports backplane port A, it is recommended that the NMM be installed in Slot 1. Carefully slide the module into an open slot in the chassis. Align the module with the installation guides and ensure that the module is firmly seated against the backplane. Secure the module by fastening the front panel thumbscrew (push in and turn clockwise to tighten) to the chassis front. Verify the “Pwr” LED is ON (indicating the chassis is powered).

•Connect the UTP port via a Category 5 cable or better to a 10BASE-T Ethernet device (Management Station).

Page 8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents IConverter Network Management Module Table of Contents Overview Port Structure UTP Management Port B B B B B B B Out-of-Band Management Installation Procedure Passwords Management Options screen will be displayed Setting IP and Control Preferences Setting IP Parameters as Dhcp Client Setting NMM Passwords Setting Snmp Preferences Setting the Snmp Trap IP Host Addresses Vlan ID NMM Access the NMM Remotely Updating the NMM Firmware via the Serial Console Port Verify Operation Module Status NMMLED NMM Specifications Troubleshooting Guide Possible CausesWarranty Limitation of Warranty
Top Page Image Contents