NetComm NB504 manual Appendix E Legal & Regulatory Information, Customer Information

Page 90

Appendix E: Legal & Regulatory Information

This manual is copyright. Apart from any fair dealing for the purposes of private study, research, criticism or review, as permitted under the Copyright Act, no part may be reproduced, stored in a retrieval system or transmitted in any form, by any means, be it electronic, mechanical, recording or otherwise, without the prior written permission of NetComm Limited. NetComm Limited accepts no liability or responsibility, for consequences arising from the use of this product.

NetComm Limited reserves the right to change the specifications and operating details of this product without notice.

NetComm is a registered trademark of NetComm Limited.

All other trademarks are acknowledged the property of their respective owners.

Customer Information

ACA (Australian Communications Authority) requires you to be aware of the following information and warnings:

(1)This unit shall be connected to the Telecommunication Network through a line cord which meets the requirements of the ACA TS008 Standard.

(2)This equipment has been tested and found to comply with the Standards for C-Tick and or A-Tick as set by the ACA . These standards are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio noise and, if not installed and used in accordance with the instructions detailed within this manual, may cause interference to radio communications. However, there is no guarantee that interference will not occur with the installation of this product in your home or office. If this equipment does cause some degree of interference to radio or television reception, which can be determined by turning the equipment off and on, we encourage the user to try to correct the interference by one or more of the following measures:

•Change the direction or relocate the receiving antenna.

•Increase the separation between this equipment and the receiver.

•Connect the equipment to an alternate power outlet on a different power circuit from that to which the receiver/TV is connected.

•Consult an experienced radio/TV technician for help.

(3)The power supply that is provided with this unit is only intended for use with this product. Do not use this power supply with any other product or do not use any other power supply that is not approved for use with this product by NetComm. Failure to do so may cause damage to this product, fire or result in personal injury.

NB504 User� Guide

YML864Rev1

90

www.netcomm.com.au

Page 89 Page 91
Image 90
Page 89 Page 91
Contents User Guide Contents Virtual Servers Package contents Conventions About this GuidePurposes Overview of this User GuideIntroduction Overview of the RouterFeatures Panel Layout Front PanelRear Panel Connecting the Router Installation Environment RequirementsSystem Requirements Connecting the Router Power off your PC, Cable/DSL modem, and the routerQuick Installation Guide TCP/IP configurationSuccessful result of Ping command Quick Installation Guide Login the routerQuick Setup Quick Setup Static IP Quick Setup Wireless settings Setup Configuring the Router LoginStatus WANRouter Status Quick Setup Network1 LAN You can configure the WAN port parameters on this 2 WANWAN Static IP WAN PPPoE Click the Save button to save your settings 802.1X + Dynamic IP Settings 802.1X + Static IP Settings 10 BigPond Settings 11 L2TP Settings 12 Pptp Settings NB504 User Guide MAC Clone 13 MAC Address CloneWireless 14 Wireless menuWireless Settings 15 Wireless SettingsMode Select the desired wireless mode. The options are 15a WPA-PSK/WPA2-PSK 16 Wireless MAC address Filtering MAC FilteringModify the information Click the Save button NB504 User Guide Wireless Statistics 18 The router attached wireless stationsDhcp 19 The Dhcp menuDhcp Settings 20 Dhcp SettingsDhcp Clients List 21 Dhcp Clients ListAddress Reservation 22 Address ReservationClick the Save button when finished Forwarding Virtual Servers26 Add or Modify a Virtual Server Entry Port Triggering 27 Port Triggering28 Add or Modify a Triggering Entry 3 DMZ 29 DMZ30 UPnP Settings UPnPSecurity 31 The Security menu32 Firewall Settings FirewallIP Address Filtering 33 IP address FilteringModify the information Click the Save button Domain Filtering 35 Domain FilteringNB504 User Guide 37 MAC address Filtering NB504 User Guide Remote Management 39 Remote Management40 Advanced Security settings Advanced Security41 Thwarted DoS Host Table IP & MAC Binding Setting Binding Setting45 Find IP & MAC Binding Entry ARP List 46ARP ListStatic Routing 47 Static RoutingDynamic Ddns 11.1Dyndns.org Ddns50 Oray.net Ddns Settings Oray.net Ddns51 Comexe.cn Ddns Settings Comexe.cn DdnsSystem Tools 52 The System Tools menu53 Time settings Time54 Firmware Upgrade FirmwareFactory Defaults Backup and RestoreReboot 57 Reboot the router12.7 Log 59 System LogStatistics 60 StatisticsAppendix a FAQ Figure A-1 PPPoE Connection TypeFigure A-3 MAC Clone Want to use Netmeeting, what do I need to do? Want to build a WEB Server on the LAN, what should I do?Figure A-7 Remote Management Wireless stations cannot connect to the router Appendix B Configuring the PC Figure B-1 Add Network ProtocolConfigure TCP/IP for your computer Figure B-3 Configuration tabFigure B-5 Gateway tab Figure B-7 IP Address tab Figure B-9 DNS Configuration tab Appendix C Specifications GeneralAppendix D Glossary Appendix E Legal & Regulatory Information Customer InformationProduct Warranty Limitations of WarrantyProduct Warranty Contact Information
Top Page Image Contents