Multi-Tech Systems MVPGSM-2 manual Save & Reboot

Chapter 3: Software Installation

Actions:

•Select Outbound Phone Book o Select Add Entry

o Accept Any Number: may be selected to allow any phone number from the wireless network to initiate a SIP call to the IP address of the SIP end point listed below

o Destination Pattern: When a call from the wireless network is received, the subsequent digits received from the wireless side are used to match the destination pattern and route the call to the SIP end point with the IP address listed below

o Remove Prefix: enter any access digits (e.g. a number to get out of a PBX system) or area codes to be taken off in this field – this manipulates the number dialed by the wireless-side caller before sending the digit string to the SIP end point of the IP address below

o Add Prefix: any digits that need to be added to make a call appear as local should be put in this field – this manipulates the number dialed by the wireless-side caller before sending the digit string to the SIP end point of the IP address below

o Enter the IP address of the SIP end point where the phone number is to be routed o Protocol type

ƒSIP:

•Select Transport Protocol, Proxy and URL if needed

oThe Advanced Button will allow routing to an Alternate IP Address to be entered for times when the primary does not respond within the allotted time

•Select Inbound Phone Book

oSelect Add Entry

oAccept Any Number will allow any number received from a SIP end point to be routed to the

selected channel below

oEnter any access digits followed by the local calling code in the Remove Prefix field. Incoming SIP

calls that match these digits will be routed to the selected channel below and have those digits removed from the incoming number

oEnter any digits needed to access an outside line in the Add Prefix field. These will be added to

the prefix of the SIP inbound call

oSelect Hunting in the Channel Number field to have the VOIP use the next available channel (this

is necessary for load balancing), otherwise you can select a specific channel for the call to go out on

oAdd a description if you like

oCall Forward may be set up (details available in Chapter 5) o Select Registration Option

•Repeat the Phone Book steps for any additional entries needed

Save & Reboot

Any time that you change settings on the VOIP unit, you must choose the Save & Reboot option; otherwise all changes made will not take affect and be lost completely when the MultiVOIP GSM is reset, shutdown or you exit from the management screen.

Multi-Tech Systems, Inc. MVPGSM 23