Multi-Tech Systems MVPGSM-2 manual Wireless Interface parameter definitions

			Chapter 4: Configuring your MVPGSM
		Wireless Interface parameter definitions
Field Name	Values		Description
Select Channel	1 – 2		Select which channel you want to set parameters for.
Disable Interface	Check box		Enable or Disable the interface.
Use Module for	Check box		Enable or Disable DTMF generation. When checked, the wireless module will
DTMF Generation			generate DTMF tones to the cell network. If this is enabled, out of band DTMF
			must be set in Voice/Fax and out of band DTMF must be set to the remote SIP
			end point.
Enable Caller ID	Check box		Enable or Disable Caller ID reporting. This allows Caller ID from the cell network
			to be passed over IP.
No Response Timer	Range 5 - 20		Set the timeout in seconds, for the wireless module to wait for a valid response
			from AT commands.
Minimum Signal	Range 0 - 31		Set the lowest allowed signal quality for the wireless channel to initiate a call.
Quality Required
SIM Pincode	-
SIM PIN	Numeric		Should your SIM card get locked out, your provider can give you the PIN code
			for the SIM on this channel.
SIM PUK	Numeric		Should your SIM card get locked out, your provider can give you the PUK code
			for the SIM on this channel.
Modem Setup	-		Five areas are available for initialization strings to be sent to the internal
			wireless modules.
Copy Channel	-		Will copy all settings from the current channel to the other available channels.
(button)
Default (button)	-		Resets parameters back to their factory default settings.

Multi-Tech Systems, Inc. MVPGSM 34