Miller Electric Remote Operator Interface manual Rst, Reset Mode

5-11. Reset Mode

Program	RST
	Volts	Time	Arc Adjust
	NO
	WFS	Amps	Arc Ctl
Process			Sequence
Wire Type			Trigger Control
Gas Type			Trigger Hold
Process Set up		Adjust	Feeder Set Up

.Reset mode is not active when Program Lock is enabled.

The reset mode allows the operator to reload factory program settings for all eight active programs in the unit.

.System configuration data will be lost during the Reset operation.

Enter reset mode by turning power On and pressing the Program Push Button until the RST NO message is displayed. RST NO message will not display until after the power-up sequence is completed (approximately 20 seconds).

Program	RST				Program	RST
	Volts	Time	Arc Adjust			Volts	Time	Arc Adjust
	YES					YES
	WFS	Amps	Arc Ctl			WFS	Amps	Arc Ctl
Process				Sequence	Process			Sequence
Wire Type				Trigger Control	Wire Type			Trigger Control
Gas Type				Trigger Hold	Gas Type			Trigger Hold
Process Set up		Adjust		Feeder Set Up	Process Set up		Adjust	Feeder Set Up

Program	CYCL
	Volts	Time	Arc Adjust
	PWR
	WFS	Amps	Arc Ctl
Process			Sequence
Wire Type			Trigger Control
Gas Type			Trigger Hold
Process Set up		Adjust	Feeder Set Up

Rotate Adjust knob to change NO

to YES.

Press the Arc Control button to

confirm the reset.

The reset message is displayed for 2 seconds while factory program settings are being reloaded.

During the reset mode the following factory default programs are loaded into the unit:

Cycl Pwr message appears on the display

when programs complete loading.

Turn power off, wait 10 seconds, and turn power back on again to complete the reset operation.

.After Reset is complete, be sure to load

appropriate programs that contain the correct wire size, process, and shielding gas for the welding operation

Program 1	Pulse
	.035 Mild Steel
	90% Argon, 10% CO2
Program 2	MIG
	.035 Mild Steel
	75% Argon, 25% CO2
Program 3	Accu-pulse
	.035 Mild Steel
	90% Argon, 10% O2
Program 4	Pulse
	.045 Mild Steel
	90% Argon, 10% CO2
Program 5	MIG
	.045 Mild Steel
	75% Argon, 25% CO2
Program 6	Accu-pulse
	.045 Mild Steel
	90% Argon, 10% O2
Program 7	Pulse
	.052 Mild Steel
	90% Argon, 10% CO2
Program 8	MIG
	.052 Mild Steel
	75% Argon, 25% CO2

198 993 / 803 246-B

OM-217 834 Page 22