Multi-Tech Systems FR3100, FR3060 manual IP Address Ethernet Mask Frame Type

Page 23

Chapter 3 - Software Loading and Configuration

13.WAN: Enter the WAN network number for the Frame Relay WAN Port by clicking the Network Number box and backspacing through the default number and entering your new WAN Number. Make sure the WAN network number is the same as the MultiFRAD on the other end of the link.

The WAN network number has to be assigned by the Network Administrator and must be unique throughout the entire inter-network.

Note: The WAN port does not have the capability of learning the network number, unlike the LAN port (i.e., the WAN port does not have a file server).

14.Click OK when you are satisfied with your selections.

15.If your MultiFRAD is connected to an IP network, continue with the following steps (16 thru 21).

If no LAN is connected to the MultiFRAD, click the IP Routing Enable check box to disable IP protocol, then click OK and proceed to step 22.

16.Record the IP address protocol information for your specific network in the space provided below.

IP Address

___.___.___.___

IP Address

___.___.___.___

Ethernet
Mask	Frame Type
Mask
___.___.___.___	TYPE II/SNAP
WAN Port
Mask	Remote Address
___.___.___.___	___.___.___.___

17.The default Ethernet IP Address has to be changed to your unique LAN address. Enter an acceptable unique IP address for the Ethernet port.

18.Change the default Subnet Mask and Frame Type to the values you have assigned to your LAN port.

19.The default WAN Address has to be changed to your unique WAN address. Enter an acceptable unique WAN Address for the WAN port.

20.Change the default Subnet Mask and Remote Address for WAN to the values you have assigned to your WAN.

21.Click OK when you are satisfied with your selections.

23

Image 23

Contents User Guide Record of Revisions RevisionDescription User GuideContents Appendices Introduction and Description MultiFRAD 3000-Series IntroductionPreview of this Guide Ethernet Front Panel DescriptionComposite Link Voice/Fax Channels 1 Channels 1Channels 3 through Monitor XMT/RCV Connector Power ConnectorFrame Ground GND Connector Internal Composite Link T1 DSU ConnectorVoice/Fax Channels 1 8 Connectors Channels 3 10 ConnectorsVoice/Fax Channel Connectors Technical SpecificationsCommand Port Channel ConnectorsInstallation Valid Voice/Fax Channel Connections Safety WarningsUnpacking your MultiFRAD General Cable Connections Cabling your MultiFRADChannel Cable Connections Voice/Fax Cable Connections Default Jumper Block Positioning ProcedureSoftware Loading and Configuration Loading your Software Software Loading and Configuration MultiFRAD 3000-Series User Guide IP Address Ethernet Mask Frame Type MultiFRAD 3000-Series User Guide Software Loading and Configuration MultiFRAD 3000-Series User Guide Software Loading and Configuration MultiFRAD 3000-Series User Guide Software Loading and Configuration MultiFRAD 3000-Series User Guide Detect and Map Your DLCIs MultiFRAD 3000-Series User Guide Build Your Phone Directory Database MultiFRAD 3000-Series User Guide Click Download Setup MultiFRAD 3000-Series User Guide MultiFRAD Software Before You Begin MultiFRAD Configuration Changing IP Parameters MultiFRAD Software MultiFRAD 3000-Series User Guide Changing IPX Parameters MultiFRAD 3000-Series User Guide MultiFRAD Software Changing Bridging Parameters WAN Port Setup Point to Point Setup Frame Relay Setup MultiFRAD 3000-Series User Guide MultiFRAD Software MultiFRAD 3000-Series User Guide MultiFRAD Software Data Port Configuration FXS Interface Changing Voice/Fax Channel ParametersInterface Interface Voice/FaxFXO Interface Regional Changing the Phone Directory Database Others Setup Enable Logging of Statistics Statistics IP Statistics STP Spanning Tree Port Statistics IPX Port StatisticsWAN Statistics Snmp StatisticsPPP Statistics Data Port Statistics Frame Relay Statistics MultiFRAD 3000-Series User Guide Remote Configuration and Management Modem-Based Remote ConfigurationRemote Configuration and Management LAN-Based Warranty, Service and Tech Support Telnet Remote ManagementMultiFRAD Management Menu MultiFRAD ConfigurationRemote User Database WEB Browser ManagementRemote Configuration and Management MultiFRAD 3000-Series User Guide Warranty, Service and Tech Support On-line Warranty Registration Limited WarrantyContacting Tech Support via E-mail Tech SupportRecording MultiFRAD Information To Download a file ServiceMulti-Tech BBS To log on to the Multi-Tech BBSIf you don’t know the file name About the InternetMultiFRAD 3000-Series User Guide Appendices LAN Cables Appendix a Cabling Diagrams Command Port CableVoice/Fax Channel Connectors RS232C/V.24 * Link Cable Trunk CableCommand Port Remote Configuration CableAppendix B Regulatory Information Glossary MultiFRAD 3000-Series User Guide Glossary MultiFRAD 3000-Series User Guide Glossary MultiFRAD 3000-Series User Guide Glossary MultiFRAD 3000-Series User Guide Glossary 100 101 102 103 Index Remote Configuration

Related manuals

Manual 105 pages 51.71 Kb