Multi-Tech Systems MT3334HD8 manual CDn

MT3334HD8 User Guide

Command	Values	Description
$BAn	n = 0 or 1	Baud Adjust

&Cn	n = 0, 1, 2,
	or 4

***$BA0 Set baud adjust off, speed conversion on. (Serial port speed is independent of modem data rate.)

$BA1 Set baud adjust on, speed conversion off. (Serial port speed is same as modem data rate.)

Carrier Detect Control

&C0	Force Carrier Detect on.
*** &C1	Let Carrier Detect follow carrier signal.
&C2	Let Carrier Detect drop for time set by S24 on
	disconnect, then go high again.
&C4	Reset modem when Carrier Detect drops.

&CDn	n = 0 or 1	Cleardown at Disconnect
	*** &CD0 Enable cleardown.
		&CD1 Disable cleardown.
Ds	s = phone #	Dial
		Dial telephone number s, where s may include up to
		60 digits and the T, P, R, comma, colon, and semicolon
		characters.
DsNd	s = phone #	Store Phone Number
	d = 0 or 1	To store, enter D followed by telephone number s,
		then N followed by directory number d.
&Dn	n = 0, 1, 2,	Data Terminal Ready Control
	or 3	&D0	Modem ignores DTR signal.
		&D1	When DTR drops, the modem hangs up. While
			DTR is low, the modem accepts commands but
			will not dial or auto-answer until DTR goes high
			again.
	*** &D2		Same as &D1.
		&D3	When DTR drops, the modem hangs up and
			resets as if an ATZ or an AT&F command was
			issued.
%DCn	n = 0 or 1	Command Mode Control
	*** %DC0 Enable command mode.
		%DC1 Disable command mode.
%DFn	n = 0 or 1	Line Probe Data Format
	***	%DF0	V.34 line probe data displayed in graph format.
		%DF1	V.34 line probe data displayed in table format.
%DPn	n = 0 or 1	Line Probe Data Read
	***	%DP0 Disable reading of line probe data during the
			V.34 handshake.

%DP1 Enable reading of line probe data during the V.34 handshake.

76 CommPlete Communications Server