N-Tron 604MFXE-ST-40, 608MFX-ST, 604MFX-ST Displays and Operating Controls, LED’s Fault red LED

Page 12

DISPLAYS AND OPERATING CONTROLS

LED’s

Fault (red LED)

Status

Meaning

 

 

The 604/608MFX has detected an error. The signaling

 

ON

contact

 

 

opens at the same time.

 

OFF

No errors detected by the 604/608MFX.

 

Stby - Standby (green LED, 608MFX Only)

 

 

Status

Meaning

 

ON

The 608MFX standby function is activated, indicating the

 

 

608MFX is in the standby passive mode.

 

OFF

The standby function is deactivated.

 

Flashing

The 608MFX standby function is activated, indicating the

 

 

608MFX is in the active mode. In other words, the Ring

 

 

master has failed and the standby takes over the data

 

 

traffic.

 

RM - Redundancy Manager (green LED)

 

 

Status

Meaning

 

 

The 604/608MFX is operating in the redundancy

 

 

manager mode. The ring is operating free of errors, as

 

ON

monitored by the redundancy manager.

 

 

Note: One (and only one) 600 Series Switch must

 

 

operate as the redundancy manager in each ring.

 

 

 

 

OFF

The 608MFX is not operating in the redundancy manager

 

 

mode.

 

 

The redundancy manager has detected a break in the

 

Flashing

ring.

 

 

The 608MFX makes the connection between its two ring

 

 

ports so that a functional bus configuration is re-

 

 

established

 

 

within 300 ms.

 

12/15/05

12

Image 12
Contents Hardware Installation Guide Industrial Ethernet Switch Installation Guide 12/15/05 Electrical Safety Laser Safety 604/608MFXE Version OnlySeries Industrial Ethernet Switch Key FeaturesPackage Contents InstallationUnpacking Series Hazardous Location Installation Requirements Personnel Qualification RequirementsDIN-Rail Mounting Rack MountingApplying Power Connecting the Standard Ring Ring ManagerConnecting Multiple Rings 608MFX Only Port Assignment in the Standby ModeCannot be used as Ring Couplers Simultaneous Standby and Redundancy Manager OperationReplacing the Standby Master during operation 608MFXLED’s Fault red LED Displays and Operating ControlsDisplay Mode Meaning State = Port Status Port LED’sSelect/Set Button Two-Pin Dip Switch Setting Aging TimeIeee 802.1Q, Vlan Ieee 802.1P, QOSSerial Interface Standby-Sync Port 608MFX OnlySerial Cable HyperterminalTroubleshooting FCC Statement12/15/05 Key Specifications Emissions and Safety Approvals WarrantyOrdering Information Description Contact/Support InformationTron Limited Warranty 12/15/05