N-Tron 608MFXE-ST-80, 608MFX-ST, 604MFX-ST, 608MFXE-ST-40, 604MFXE-ST-40, 608MFXE-ST-15 manual 12/15/05

Page 3

Copyright, © N-TRON Corp., 2002

820 S. University Blvd., Suite 4E

Mobile, AL USA 36609

All rights reserved. Reproduction, adaptation, or translation without prior written permission from N-TRON Corp. is prohibited, except as allowed under copyright laws.

Ethernet is a registered trademark of Xerox Corporation. All other product names, company names, logos or other designations mentioned herein are trademarks of their respective owners.

The information contained in this document is subject to change without notice. N-TRON Corp. makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability or fitness for a particular purpose. In no event shall N-TRON Corp. be liable for any incidental, special, indirect, or consequential damages whatsoever included but not limited to lost profits arising out of errors or omissions in this manual or the information contained herein.

Warning

Do not perform any services on the unit unless qualified to do so. Do not substitute unauthorized parts or make unauthorized modifications to the unit.

Do not operate the unit with the top cover removed, as this could create a shock or fire hazard.

Do not block the air vents on the sides or the top of the unit.

Do not operate the equipment in the presence of flammable gasses or fumes. Operating electrical equipment in such an environment constitutes a definite safety hazard.

12/15/05

3

Image 3
Contents Hardware Installation Guide Industrial Ethernet Switch Installation Guide 12/15/05 Laser Safety 604/608MFXE Version Only Electrical SafetyKey Features Series Industrial Ethernet SwitchPackage Contents InstallationUnpacking Rack Mounting Series Hazardous Location Installation RequirementsPersonnel Qualification Requirements DIN-Rail MountingApplying Power Ring Manager Connecting the Standard RingSimultaneous Standby and Redundancy Manager Operation Connecting Multiple Rings 608MFX OnlyPort Assignment in the Standby Mode Cannot be used as Ring Couplers608MFX Replacing the Standby Master during operationDisplays and Operating Controls LED’s Fault red LEDPort LED’s Display Mode Meaning State = Port StatusSelect/Set Button Ieee 802.1P, QOS Two-Pin Dip Switch SettingAging Time Ieee 802.1Q, VlanStandby-Sync Port 608MFX Only Serial InterfaceHyperterminal Serial CableFCC Statement Troubleshooting12/15/05 Contact/Support Information Key Specifications Emissions and Safety ApprovalsWarranty Ordering Information DescriptionTron Limited Warranty 12/15/05