N-Tron 604MFXE-ST-40, 608MFX-ST manual Electrical Safety, Laser Safety 604/608MFXE Version Only

Page 4

Safety Warnings

ELECTRICAL SAFETY

WARNING: Disconnect the power cable before removing the enclosure top.

WARNING: Do not operate the unit with the top cover removed.

WARNING: Do not work on equipment or cables during periods of lightning activity.

WARNING: Do not perform any services on the unit unless qualified to do so.

WARNING: Do not block the air vents.

WARNING: Observe proper DC Voltage polarity when installing power input cables. Reversing voltage polarity can cause permanent damage to the unit and void the warranty.

LASER SAFETY (604/608MFXE Version Only)

WARNING: CLASS 1 Laser Product.

WARNING: Do not stare into the Laser Beam.

12/15/05

4

Image 4
Contents Hardware Installation Guide Industrial Ethernet Switch Installation Guide 12/15/05 Electrical Safety Laser Safety 604/608MFXE Version OnlySeries Industrial Ethernet Switch Key FeaturesInstallation Package ContentsUnpacking Series Hazardous Location Installation Requirements Personnel Qualification RequirementsDIN-Rail Mounting Rack MountingApplying Power Connecting the Standard Ring Ring ManagerConnecting Multiple Rings 608MFX Only Port Assignment in the Standby ModeCannot be used as Ring Couplers Simultaneous Standby and Redundancy Manager OperationReplacing the Standby Master during operation 608MFXLED’s Fault red LED Displays and Operating ControlsDisplay Mode Meaning State = Port Status Port LED’sSelect/Set Button Two-Pin Dip Switch Setting Aging TimeIeee 802.1Q, Vlan Ieee 802.1P, QOSSerial Interface Standby-Sync Port 608MFX OnlySerial Cable HyperterminalTroubleshooting FCC Statement12/15/05 Key Specifications Emissions and Safety Approvals WarrantyOrdering Information Description Contact/Support InformationTron Limited Warranty 12/15/05