Port LED’s
The display Mode is indicated by the LED pair labeled “Display Mode”, and the state is given by the legend on the front of the 600 Series Switch. To transition between these Display Modes, the Select/Set button must be pressed briefly (similar to left mouse click). The four states are: Port Status, 100Mbit/s, Full Duplex, Fault Mask.
Display Mode: | Meaning |
State = Port Status |
|
OFF | No Valid Connection to the port. |
Green | Valid Connection to the port (good link). |
| Flashes green once per cycle, port switched |
| to standby |
| Flashes green three time per cycle, port is |
| disabled by configuration |
Yellow | Indicates Port is actively receiving data |
Display Mode: | Meaning |
State = 100 Mbps |
|
OFF | Port operating at 10 Mbps |
Green | Port operating at 100 Mbps |
Display Mode: | Meaning |
State = Full Duplex |
|
OFF | Port operating half duplex |
GREEN | Port operating full duplex |
Display Mode: | Meaning |
State = Fault Mask |
|
OFF | Port is not currently monitored |
Green | Port is currently monitored |
12/15/05 | 13 |