Prev unit Down | Lightwave Communications 2X16 specification

Lightwave Communications

PC ServerSwitch 2x16

3.2.1 System Setup: Port Setup

Edit Port Names - Select the desired port using the up and down arrows and the “Enter” key. Press 'Esc' to return to the previous menu screen.

Port Setup

Edit Port Names

+Port	1
+Port	2	Default is blank
+Port	3	Enter a Port
+Port	4	Name here;
+Port	5	alpha-numerics
+Port	6	and
-Port	7	+ -	/ . ; are OK
+Port	8	15	characters

F8 toggles Inactive msg		+/-
keypad + or	- toggles autoscan
Enter to	edit a port	name
; Port Autoscan Enabled
Prev unit	Down

Enter any name, up to 15 characters long. Note that case-sensitivity of port names may be enabled or disabled system-wide, if required. Valid characters include A through Z, a through z, digits 1 through 9 and 0, and + (plus), - (minus), / (slash),

. (period) and : (colon).

•The symbol on-screen represents Auto Scan Enabled for this port. A Port with the symbol showing will be included in a scan of active ports. Select which ports should be scanned during auto scan mode (default is all ports). Toggle auto scan on/off for each port using the + or - keys.

•The + and - symbol before the Port number shows the LCD Inactive message status (+ indicates that the front panel LCD will display an error message for this port, - indicates that the front panel error message is disabled for this port). To change this setting, select the Port and press F8 to turn this option On or Off.

Note: Refer to Section 3.1.1 for Auto-Scan system setup options.

www.lightwavecom.com

Page 12 of 24