Lightwave Communications | PC ServerSwitch 2x16 |
display shows which Server Port is connected to which Console (A or B) on the top two lines, and also shows
The display is 4 lines by 20 characters in each line. Note that the display will only show Console A or Console B information at any time (not both Consoles at the same time).
B:Port 13 name here Cable Power Removed
Port 10 | P10 |
The Port Name information entered from the System Setup screens (using the on- screen System Setup commands) will be displayed on the display. You can change the active port on the PC ServerSwitch 2x16 either via the
If multiple 2x16 units are cascaded, the display information is repeated on all front panel displays.
Front Panel Controls
The front panel display shows which Console is connected to which Server; or, if 'disabled' appears, that Console is not connected to any servers at that time.
•Press and release the Up arrow button to select the next Server number. If you reach the highest port number, the next value is 'disabled', and then it restarts at Port 1.
•Press and release the Down arrow button to select the previous server number. If you reach the lowest number, the next value is 'disabled' followed by the highest port number.
•To switch between Console A and Console B, press and release both the UP and DOWN buttons on the front panel at the same time. This option is blocked while another user is accessing the System using the
•Front panel controls are disabled on Auxiliary 2x16 units; only the Master 2x16 unit's front panel buttons will operate.
To switch between Console A and Console B, press both the UP and DOWN buttons on the front panel at the same time. This option is blocked while another user is accessing the System using the
3.4 Error Messages
The last two lines of the front panel display will show an error message if an error condition exists. The third display line will identify the error, and the fourth display line will identify which Server Port is involved if it is a Server error.
The most common Error Message will be that of a Server's Keyboard's cord being disconnected. Note that the Mouse port is not sensed for disconnection.
www.lightwavecom.com | Page 15 of 24 |