Linear RE-1 manual Optional Keyswitch, Keyswitch Installation

OPTIONAL KEYSWITCH

A keyswitch can be installed in the RE-1 Entry System to provide keyed access. The RE-1 case is designed to accept the following keyswitch:

KNOX COMPANY MODEL 3501

KNOX COMPANY

800-552-5669

www.knoxbox.com

Keyswitch Installation

1.Disconnect the wiring harness connector and remove the antenna terminal block. Remove the four circuit board retaining screws and the RE-1 circuit board (see Figure 18).

2.Remove the screw and washer that retain the keyswitch hole access plate (see Figure 19).

3.Hold the lock cover and plastic spacer in place on the RE-1 case. Secure the assembly with four screws, lock washers, and nuts. Slide the keyswitch into the hole, oriented as shown (see Figure 20). Secure the keyswitch with the large switch nut. Use bolt cutters to trim the two screws closest to the case edge so they will clear the circuit board (see Figure 21).

4.Plug the two keyswitch snap-on wire leads (supplied with the switch) onto the keyswitch COM and N.O. pins (see Figure 21).

5.Replace the RE-1 circuit board. Secure the board with the four screws. Reconnect the antenna terminal block and wiring harness connector.

6.Connect one keyswitch wire to the RE-1 OPEN #1 terminal. Connect the other keyswitch wire to the RE-1 COMMON terminal.

DISCONNECT THESE

TWO CONNECTORS

REMOVE

CIRCUIT

BOARD

REMOVE THESE

4 SCREWS

Figure 18. Removing the RE-1 Circuit Board

	INSTALL COVER PLATE
	AND SPACER WITH FOUR
	SCREWS, LOCKNUTS, & NUTS
	COVER
SPACER	PLATE
	ASSEMBLY
INSERT KEYSWITCH
INTO HOLE WITH
KEYSLOT ORIENTED
AS SHOWN

Figure 20. Installing the Keyswitch

COM

SWITCH N.O.

PINS

	SWITCH SECURED
	WITH LARGE NUT	BOLTS CUT SHORT
CONNECT SWITCH WIRES
		TO CLEAR CIRCUIT
TO COM AND N.O. PINS		BOARD

Figure 21. Keyswitch Wire Connections

REMOVE THE

SCREW AND

WASHER

REMOVE THE

COVER PLATE

TRANSFORMER TRANSFORMER BATTERY NEGATIVE BATTERY POSITIVE SENSE #1 OPEN #1 SENSE #2 OPEN #2

COMMON

KEYPAD CLK

KEYPAD DVAL

KEYPAD DAT 0

KEYPAD DAT 1

KEYPAD GND

KEYPAD PWR

RE-1

TERMINALS

ACCESS

KEYSWITCH

NOTE: THE KEYSWITCH CAN BE WIRED TO THE OPEN #2 TERMINAL TO CONTROL

A SECOND GATE OR DOOR

Figure 19. Removing the Keyswitch Hole Access Plate

Figure 22. Keyswitch Wiring

10