Optional Cctv Camera, Camera Installation

OPTIONAL CCTV CAMERA

Linear’s Model RE-BWC1 (P/N ACP00886A) CCTV camera can be installed inside the RE-1 Entry System. The camera provides a video signal for viewing the area in front of the entry system.

The camera is continuously powered by the RE-1. The camera’s infrared light emitters illuminate the area directly on front of the entry system for nighttime or low light operation.

The RE -1 CAMERA jack is used to connect the camera to the main circuit board with the double-ended modular cable supplied with the camera. This cable routes power to, and video from the camera.

The RE-1 VIDEO jack is for connection to a video cable with aType “BNC” connector. Up to 300 feet of 75-ohm RG-59 video cable can be used. Longer cable runs may require the use of a video ampliﬁ er.

Camera Installation

1.Disconnect the wiring harness connector and remove the antenna terminal block. Remove the four circuit board retaining screws and the RE-1 circuit board (see Figure 23).

2.Mount the camera assembly into the RE-1 case. Secure the camera with the two screws provided (see Figure 24).

3.Connect the wiring harness 2-pin lighting power wiring connector onto the camera’s infrared lighting power connector (see Figure 25).

4.Replace the RE-1 circuit board. Secure the board with the four screws. Reconnect the antenna terminal block and wiring harness connector.

5.Plug the double-ended modular cable into camera’s jack and the RE-1 CAMERA jack (see Figure 26).

6.Connect the video cable to the RE-1 VIDEO connector (see Figure 27).

DISCONNECT THESE

TWO CONNECTORS

REMOVE

CIRCUIT

BOARD

REMOVE THESE

4 SCREWS

Figure 23. Removing the RE-1 Circuit Board

SECURE THE CAMERA ASSEMBLY

WITH TWO SCREWS

IMPORTANT!

TO PREVENT INTERNAL

INFRARED LIGHT FROM

ENTERING THE CAMERA,

BE SURE THE FOAM GASKET

AROUND THE CAMERA'S

LENS PRESSES FIRMLY AGAINST

THE RE-1'S FACEPLATE

Figure 24. Mounting the Camera in the RE-1

INSERT WIRING

HARNESS PLUG

INTO THE 2-PIN

LIGHTING

CONNECTOR

Figure 25. Connecting the Camera’s Lighting Power

PLUG THE CAMERA CABLE	NOTE: ALTERNATELY, THE CAMERA CAN BE
PLUG THE CAMERA CABLE	CONNECTED DIRECTLY TO ANY OF LINEAR'S
INTO THE CAMERA'S JACK	KEEPSAFER™ BRAND MONITORS
AND THE RE-1'S CAMERA JACK

CAMERA

CABLE FROM

CAMERA'S JACK

RE-1

CAMERA

JACK

Figure 26. Connecting the Camera Cable

CONNECT THE VIDEO CABLE FOR THE MONITOR

TO THE RE-1'S VIDEO OUTPUT CONNECTOR

Linear RE-1 manual Optional Cctv Camera, Camera Installation