Component Locations, Keypad | Linear RE-1 manual

2	4
	CALL

13 14

11 15

9 7

COMPONENT LOCATIONS

1KEYPAD

Die-cast metal 12-key keypad with tactile action. For system programming and keying in entry codes.

2DOWNLIGHT

Illuminates keypad and visitor operation buttons. The light can be programmed to operate dusk to dawn and adjusts its time depending on the system’s geographic location.

3OPTIONAL CCTV CAMERA

Location for the optional Model RE-BWC1 CCTV camera.The camera views the keypad area and has infrared lighting for nighttime use.

4MICROPHONE

The high-sensitivity microphone monitors sound at the keypad area for the entry system’s speakerphone.

5CALL BUTTON

Pressing this button causes the system to call the residence telephones with a distinctive ring signal.

6HELP BUTTON

Pressing this button causes the system to play the help message to instruct the visitor on system use.

7SPEAKER

Weatherproof speaker for system operation and programming.

8INTEGRAL ANTENNA

Hidden antenna receives wireless radio signals from transmitters.

9OPTIONAL KEYLOCK

Location for mounting access keylock. (MEDECO keylock with stainless steel cover shown).

10MAIN TERMINAL BLOCK

For power, backup battery, sense inputs, open request inputs, and remote keypad connections.

11SPEAKERPHONE VOLUME CONTROL

Controls the audio level produced by the speaker during communications between the visitor and the resident.

12RELAY TERMINAL BLOCK

For Relay #1 and Relay #2 output connections to the access control devices.

13RELAY INDICATORS

Indicators for Relay #1 and Relay #2 will light when the relay is activated.

14ANTENNA TERMINAL BLOCK

For shield and center conductor connection of the coax cable from the system’s built-in radio antenna.

15LINE MONITOR JUMPER

For testing and troubleshooting. Remove jumper to listen to telephone line audio through the speaker.

16DIGITAL SPEECH VOLUME CONTROL

Controls the audio level of the voice synthesizer. This adjustment effects the audio level of the voice synthesizer and system tone from the speaker.

17STATUS INDICATORS

Six indicators light to display system power, radio, and modem status.

18VIDEO CONNECTOR

For cable connection to a video monitor. (Optional Model RE-BWC CCTV camera required).

19CAMERA CONNECTOR

Provides power and video connection for the optional Model RE- BWC CCTV camera.

20RESTART BUTTON

Pressing this button restarts the system. This button DOES NOT erase any programming data.

21TELEPHONE TERMINAL BLOCK

For telephone line and earth ground connections.