LSI ICH6R, D815-000319-00 manual Using a Pre-loaded System Drive

Note that the logical drive should be at a RAID 1 level to start check consistency. If you select a RAID 0 logical drive, a message displays stating that a check consistency cannot be performed. To de-select a logical drive, press the space bar again.

Step 3. Press <F10>.

Step 4. At the prompt, select Yes to start check consistency and press <Enter>.

If you press <Esc> while the check consistency is in progress, the following options display:

◊Stop: The CU stores the percentage of the check consistency already completed. When you restart the check consistency, it continues from the last percentage completed rather than from zero percent.

◊Continue: Check consistency continues normally.

◊Abort: The check consistency is completely aborted. If you restart check consistency, it begins at zero percent.

3.8Using a Pre-loaded System Drive

You can use the controller as an adapter for this drive by performing the following steps:

Step 1. Connect the drive to the port on the controller.

Step 2. Boot the computer.

Step 3. Start the CU.

Step 4. Select Configure→ Easy Configuration from the menu.

Step 5. Press the cursor keys to select the pre-loaded drive.

Step 6. Press the spacebar.

The pre-loaded drive now becomes an array element.

Step 7. Press <Enter>. The pre-loaded drive is a one-disk array.

Step 8. Display the logical drive configuration screen.

Step 9. Highlight Accept and press <Enter>.

Step 10. Press <Esc> and select Yes at the prompt to save the configuration.

3-12 BIOS Configuration Utility

Copyright © 2004 by LSI Logic Corporation. All rights reserved.