LSI ICH6R, D815-000319-00 manual Embedded Sata Software RAID Problem Report Form

Table 7.1	Problems and Suggested Solutions
Problem		Suggested Solution
One of the hard drives in a mirrored (RAID		Replace the failed drive with another drive that has the same or
1) array has failed.		greater capacity.
You insert a new drive with no		Press any key to enter the BIOS Configuration Utility (Ctrl-M) to
configuration into the slot which is already		configure the new drive. Mark the drive as one of the following:
part of a mirrored (RAID 1) array.		• Failed - If the AutoRebuild option is disabled in the configuration
		utility
		• Rebuilding - If the AutoRebuild option is enabled in the
		configuration utility
You insert a new drive with no		Press any key to enter the BIOS Configuration Utility (Ctrl-M) to
configuration into the slot which is already		configure the new drive.
part of a striped (RAID 0) array or there is
a striped (RAID 0) array by itself in the
system.

7.2Embedded SATA Software RAID Problem Report Form

Table 7-2 contains a form you can just to record problems with the Embedded SATA Software RAID.

7-2Troubleshooting

Copyright © 2004 by LSI Logic Corporation. All rights reserved.