LevelOne FPS-2111TXU, FPS-2003TXU, FPS-2101USB, FPS-2013TXU, FPS-2101TXU manual Configuration Methods

Page 31

Level One Printer Servers

Configuration Methods

To support the widest possible range of users , the LevelOne Printer Server is supplied with the utilities listed in the following table.

Note that this document covers only BiAdmin with Novell's Client 32 software installed on your PC. For more details about the other methods, refer to the full User Manual on the CD-ROM.

BiAdmin If possible, you should use the supplied BiAdmin utility for configuration. BiAdmin is a powerful, user-friendly program which runs under Windows 95/98/NT.

See Chapter 4 - BiAdmin Utility for details on installing this program, and general instructions on usage.

BiAdmin works best if you have Novell NetWare Client 32 for Windows installed.

Quickset QUICKSET is a DOS-based command-line program. It will configure the LevelOne Printer Server and the current Novell server in a single operation. However, it provides few options.

PSConfig PSConfig is a DOS-based, menu-driven program. It uses the IPX/SPX protocol to connect to the LevelOne Printer Server, so your PC must load the IPX/SPX drivers before PSConfig can be used.

PSConfig can only configure the LevelOne Printer Server itself. You must use the NetWare’s PCONSOLE or NWAdmin to configure the NetWare server.

- 28 -

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Level One Printer Servers Table of Contents Windows NT Server TCP/IP Special FeaturesTroubleshooting SpecificationsIntroduction FeaturesYear 2000 Compliance Safety Instructions Package Contents EPS-3001TU 10BaseT Direct Attach ModelsDescription Item Description FPS-3001TXU 100BaseT Direct AttachFPS-2111TXU FPS-2101TXU FPS-2013TXU FPS-2003TXU FPS-2101USB Green LED Red/Orange LED Status Description LED IndicatorsDIP Switches FPS-2101TXU & FPS-2003TXU DIP Switches FPS-2111TXU & FPS-2013TXUTo restore the factory default settings Diagnostic Push ButtonTo generate a Diagnostic print out Connect the Printers LAN InstallationProcedure Find the Default LevelOne Printer Server NamePower Up and Check Required Configuration ConfigurationConfiguration Methods & Utilities WPConfig WebAdminAdditional Recommendations BiAdmin Utility ProgramInstallation RequirementsMain Screen BiAdmin Main ScreenDevice List GroupsStatus Icons Configuration IconsOther Icons Status Menu Menu OptionsInitDevice Menu Diagnostics menu Configuration MenuControl Menu Printing AppleTalk SetupAppleTalk Software RequirementsMacintosh Software Advanced Setup and ManagementChanging the Device Configuration Windows SoftwareAPPCOMM1 No APPCOMM2 No APPCOMM4 No AppleTalk SettingsDevice Name Apple ZoneOverview Configuring NetWareConfiguring the LevelOne Printer Server NetWareConfiguration Methods Preparation Using BiAdmin with ClientData Print Server Mode BinderyButtons Quickset Button Bindery NetWare Configuration Button BinderyIf you have multiple File Servers If you have a single File Server Select Printer Port Bindery Printer ButtonAssign Queues Bindery Assigning Printer Queues RequiredTo assign operators to Queues Optional To Assign Users to Queues RequiredNetWare Password Bindery PS Mode PasswordPrint Server Mode NDS Quickset Button NDS NetWare Configuration Button NDSSelect Printer Port NDS To assign operators to the Print Queue Optional Assign Users to Queue NDS PS modeNetWare Password NDS PS Mode Password NDSRemote Printer Mode Bindery Current Context Remote Printer Mode NDSOverview Ndps NetWareCreating an Ndps Manager Object Load Ndpsm Creating an Ndps Printer AgentProcedure Workstation ConfigurationNdps Manager Client Example Unix Web Browser ConfigurationExample Windows Connecting to the LevelOne Printer Server Data TCP/IP Screen TCP/IP ConfigurationString Before Job Logical Printer ConfigurationLogical Printer Setup Data Other ScreensOperation TelnetSoftware Requirements IP Address ConfigurationProcedure UnixDirect Socket Interface Using BootpUsing Rarp Printing Methods OverviewLPD on IBM AIX LPD Printing ConfigurationFTP File Transfer Protocol LPD on System Action Sample CommandAdding Remote Printers LPD on BSD Printing using LPD Logical Printer No Socket No Printing Using DSIPrinting Using PSfilter Other Printing MethodsWindows NT Server TCP/IP LevelOne Printer Server ConfigurationHost File Entry Optional Windows NT Host ConfigurationWindows Preparing for TCP/IP PrintingAdding a TCP/IP Remote Printer Windows NTWindows NT Server TCP/IP Printing with Windows NT Command LineWindows Applications Windows Peer-to-Peer SetupAdd Port Peer-to-peer Print Driver If your LevelOne Printer Server is not listedManagement Configure Printer PortBanner Port OptionsRetry Interval Mail Server Special FeaturesInternet Printing System RequirementsUser Client Requirements Internet Printer ServerInstallation User Software Internet Mail Printing ConfigurationUser Software Following data must be provided Checking the Printer Driver Using the new PortPrinting through the Internet Canceling a Print JobTrap Receiving Station Settings Configuring the LevelOne Printer Server for SnmpSnmp Settings Management Station SettingsTrap Severity Hardware Problems TroubleshootingProblem No All the LevelOne Printer Server’s LEDs are off Directional Problem NoBiAdmin is grayed out, even though my printer in bi Printing GeneralProblem No My EPS file doesn’t print with the correct fonts Problem No Why do I get an incorrect printout?Problem No My document didn’t print to the right printer Problem No My file doesn’t print with the correct fontsLevel One Printer Servers NetWare 4.x bindery and NDS modes Problem No My LevelOne Printer Server prints garbageNetWare NetWare 2.xSet Allow service by current print servers to YES Troubleshooting Problem No PSConfig shows No Response Then select Print Server Configuration and select QueuesCannot receive Notify message in NetWare 4.x environment TCP/IP Unix & Windows NT Problem No LevelOne Printer Server device is not recognizedProblem No I can’t print using PSfilter Problem No I can’t print using LPDWindows Peer-to-peer To remove an existing printer port installationTroubleshooting Then select File Properties Details Problem No Two print jobs are printing on the same Problem No I don’t know my Mail Server’s IP AddressProblem No Plain text E Mails are not printed Problem No a print job is printing garbageSelect Properties Details Problem No Only the banner page was printedFCC Statement SpecificationsDirect Attach Models EPS-3001TUFPS-3001TXU Parallel Port Pin Assignments Environmental SpecificationsOther Models Strobe To printer +Data Level One Printer Servers

FPS-2111TXU, FPS-2101TXU, FPS-2003TXU, FPS-2013TXU, FPS-2101USB specifications

LevelOne has established itself as a reputable brand that offers a diverse range of high-quality networking products. Among its impressive catalog, the devices EPS-3001TU, FPS-2003TXU, FPS-2101USB, FPS-2101TXU, and FPS-2111TXU stand out for their unique features and capabilities tailored to meet various networking needs.

The LevelOne EPS-3001TU is an advanced PoE (Power over Ethernet) injector that enhances network efficiency by transmitting both power and data through a single cable. This device supports IEEE 802.3af PoE standards, making it compatible with a wide array of PoE-enabled devices such as IP cameras and wireless access points. With a compact design, the EPS-3001TU is easy to install and ideal for environments where space is a concern. Its LED indicators provide real-time feedback on power and data transmission, ensuring reliable performance at all times.

The FPS-2003TXU is a robust network switch designed to facilitate seamless data flow in various applications. Featuring 3 Gigabit Ethernet ports, it offers a high-speed data transfer rate that minimizes latency. Plug-and-play functionality allows for effortless integration into existing networks, while its compact and fanless design ensures quiet operation, making it suitable for office environments. The FPS-2003TXU also boasts energy-efficient technology, reducing overall power consumption without compromising performance.

The FPS-2101USB, on the other hand, combines the traditional switch functionality with USB connectivity. This unique feature allows users to easily connect USB devices directly, thereby broadening the scope of network sharing. Ideal for small offices, the FPS-2101USB supports multiple simultaneous connections, enhancing productivity and collaboration among users. The device is designed for simplicity, ensuring easy setup and management.

Similarly, the FPS-2101TXU and FPS-2111TXU are reliable managed switches that offer extensive management features and enhanced security protocols. Both models come with multiple ports for optimal connectivity and support high-definition video and voice traffic. They are equipped with VLAN support, allowing for efficient traffic segmentation and improved network performance. Moreover, their robust security features, including port security and access control lists, ensure that network integrity is maintained.

In conclusion, LevelOne's EPS-3001TU, FPS-2003TXU, FPS-2101USB, FPS-2101TXU, and FPS-2111TXU devices provide a strong foundation for building and managing efficient networks. With a combination of innovative features, user-friendly design, and reliable performance, these products cater to the needs of both home and business environments, ensuring that users get the most out of their networking infrastructure.
Top Page Image Contents