Lantronix LX6 manual Line and Tunnel Settings, Line Settings, Line Configuration Settings

6:Line and Tunnel Settings

The XPort Pro Lx6 embedded device server contains one line using a standard RS232/RS485 serial port. This line may be configured to operate in the following modes:

RS232

RS485 Full Duplex (also compatible with RS-422)

RS485 Half Duplex, with and without termination impedance

All serial settings such as Baud Rate, Parity, Data Bits, etc, apply to these lines.

Line Settings

The Line Settings allow configuration of the serial lines (ports).

Some settings may be specific to only certain lines. Such settings are noted below.

	Table 6-1 Line Configuration Settings
Line Settings	Description
Name	Enter a name or short description for the line, if desired. By default, there is
	no name specified. A name that contains white space must be quoted.
Interface	Set the interface type for the Line. The default is RS232 for Line 1.
	Choices are:
	 RS232
	 RS485 Full-Duplex
	 RS485 Half-Duplex
Termination	Select to Enable or Disable Line Termination. The default is Disable.
	Note: This setting is only relevant for Line 1 with Interface type RS485 Half-
	Duplex.
State	Select to Enable or Disable the operational state of the Line. The default is
	Enable.
Protocol	Set the operational protocol for the Line. The default is Tunnel. Choices are:
	 None
	 Tunnel = Serial-Network tunneling protocol.
Baud Rate	Set the Baud Rate (speed) of the Line. The default is 9600.
	Any set speed between 300 and 921600 may be selected: 300, 600, 1200,
	2400, 4800, 9600, 19200, 38400, 57600, 115200, 230400, 921600.	When
	selecting a Custom baud rate, you may manually enter any value between
	300 and 921600.
	Note: Custom baud rates are not supported when a line is configured for
	Command Mode.
Parity	Set the Parity of the Line. The default is None.
Data Bits	Set the number of data bits for the Line. The default is 8.
Stop Bits	Set the number of stop bits for the Line. The default is 1.
Flow Control	Set the flow control for the Line. The default is None.

XPort® Pro Lx6 Embedded Device Server User Guide 27