Lantronix LX6 manual Tunnel Accept Mode Settings, Tunnel Accept Mode Description Settings

		6: Line and Tunnel Settings
	Table 6-5 Tunnel Accept Mode Settings
Tunnel Accept Mode		Description
Settings
Mode		Set the method used to start a tunnel in Accept mode. Choices are:
		 Disable = do not accept an incoming connection.
		 Always = accept an incoming connection (default).
		 Any Character = start waiting for an incoming connection when any
		character is read on the serial line.
		 Start Character = start waiting for an incoming connection when the
		start character for the selected tunnel is read on the serial line.
		 Modem Control Asserted = start waiting for an incoming connection as
		long as the Modem Control pin (DSR) is asserted on the serial line until
		a connection is made.
		 Modem Emulation = start waiting for an incoming connection when
		triggered by modem emulation AT commands. Connect mode must
		also be set to Modem Emulation.
Local Port		Set the port number for use as the network local port. The default local port
		number for each supported serial line number progresses sequentially in
		equal value so that Tunnel X : 1000X. For example:
		 Tunnel 1 : 10001
		 Tunnel 2 : 10002
Protocol		Select the protocol type for use with Accept Mode:
		 TCP (default protocol)
		 TCP AES
		 Telnet
TCP Keep Alive		Enter the time, in milliseconds, the XPort Pro Lx6 waits during a silent TCP
		connection before checking if the currently connected network device is
		still on the network. If the unit gets no response after 1 attempt, it drops
		the connection. Enter 0 to disable.
Flush Serial		Set whether the serial line data buffer is flushed upon a new network
		connection. Choices are:
		 Enabled = serial data buffer is flushed on network connection
		 Disabled = serial data buffer is not flushed on network connection
		(default)
Block Serial		Set whether Block Serial is enabled for debugging purposes. Choices are:
		 Enabled = if Enabled, incoming characters from the serial line will not
		be forwarded to the network. Instead, they will be buffered and will
		eventually flow off the serial line if hardware or software flow control is
		configured.
		 Disabled = this is the default setting; incoming characters from the
		Serial Line are sent on into the network. Any buffered characters are
		sent first.
Block Network		Set whether Block Network is enabled for debugging purposes. Choices
		are:
		 Enabled = if Enabled, incoming characters from the network will not be
		forwarded to the Serial Line. Instead, they will be buffered and will
		eventually flow off the network side.
		 Disabled = this is the default setting; incoming characters from the
		network are sent on into the Serial Line. Any buffered characters are
		sent first.

XPort® Pro Lx6 Embedded Device Server User Guide 32