LevelOne 11g USB Adapter w/LCD WiFi Detector, WNC-0304USB user manual Ssid

Page 21

 

When the adapter works in 11b mode, the maximum data rate is

 

11Mbps so that there are only “Auto/1/2/5.5/11Mbps” options you

 

can select.

SSID

The SSID (up to 32 printable ASCII characters) is the unique

 

name identified in a WLAN. The ID prevents the unintentional

 

merging of two co-located WLANs.

 

You may specify a SSID for the adapter and then only the device

 

with the same SSID can interconnect to the adapter.

Any

If “Any“ check box is enabled, the adapter will survey and connect

 

to one of the available wireless stations without checking the

 

consistency of channel and SSID with the wireless station.

Network Type

Ad-Hoc– This mode enables wireless network adapters

 

interconnecting without through AP or Router. Select this mode if

 

there is no AP or Router in the network.

 

Infrastructure – This operation mode requires the presence of an

 

802.11 Access Point. All communication is done via the Access

 

Point or Router.

Change/Apply

Click “Change“ will enable you to setup the parameters of

 

“General Connection Setting“. In the meantime, the button will

 

change to “Apply“ for you to confirm your settings.

Encryption Setting

In the block, users may enable/disable WEP and WPA encryption

 

within the network. Please refer to Section 5.3 for more

 

description.

 

 

19

Image 21
Contents LevelOne Contents Introduction FeaturesSpecifications Package Contents How to charge the battery of Wi-Fi Detector How to use the Wi-Fi Detector Page Seek/Lock Install the Configuration Utility How to install the driver and utilityPage Page Install the USB adapter Click Finish to complete the installation First Way Using the Configuration UtilitySecond Way How to configure the utility Wireless Connection Status Bssid General Connection Setting Ssid Page WEP and WPA Encryption WEP SettingPage Page 2 WPA/WPA2 Setting Page WEP KEY Setting Continuous Access Mode CAM The adapter will always set Advanced SettingsMaximum Power-Saving mode AP Connection Status Software AP ModeAP General Connection Setting WEP Should use the shorter preamble type MAC Address Filter Link Installation Page Page Page Page What is the Ieee 802.11g standard? TroubleshootingWhat is the Ieee 802.11b standard? What does Ieee 802.11 feature support?What is BSS ID? What is Infrastructure?What is WEP? What is TKIP?What is Spread Spectrum? What is DSSS?What is FHSS?And what are their differences?What is the maximum AP that can be detected? What is the maximum detection distance?