LevelOne WCS-2060, FCS-1060 user manual Check Network Settings

Page 11

For more detailed usage of the Installation Wizard, please refer to the user manual of the Installation Wizard included in the product CDROM to find the location of the Network Camera. There may be many Network Cameras in the local network. Users can differentiate the Network Cameras with the MAC address. The MAC address is printed on the back of the Network Camera body. Initial Access to the Network Camera

Check Network Settings

FCS-1060/WCS-2060 IP Network Camera can be connected either before or immediately after software installation onto the Local Area Network. The Administrator should complete the network settings on the configuration page, including the correct subnet mask and IP address of gateway and DNS. Ask your network administrator or Internet service provider for the detail information. By default the Network Camera requires the Administrator to run installation every time it reboots. If the network settings are to remain unchanged, disable the Install option. Refer to “Network settings” on the System Configuration page for details. If any setting is entered incorrectly and cannot proceed to setting up the Network Camera, restore the factory settings following the steps

11

Image 11

Contents LevelOne Before You Use This Product Table of Contents FTP Package Contents Hardware installation InstallationTo install in wireless LAN WCS-2060 Only To install in EthernetSoftware Installation Page Page Check Network Settings Add Password to Prevent Unauthorized Access Authentication How to UseInstalling plug-in Main Screen with Camera View ConfigurationClient Settings Primary user’s capabilityView capabilities Tilt speed Pan/tilt control buttonsAs Play Pan speedPatrol PanClient settings Url http//Network Camera/client.html For Viewing by Mobile Phone Administrator’s capabilityFine-tuning for Best Performance Only Quality Images Will Do Somewhere Between Real-time and Clear ImagesFor Best Real-time Video Images Build a security application Protect Network Camera by passwordsOpening accounts for new users Software revision upgrade Page Definitions in Configuration System parameters Security settings Get IP address automatically & Use fixed IP address Network settingsNetwork type LAN & PPPoERtsp Streaming Wlan Configuration WCS-2060 Only Tkip AES Ddns Access List Video orientation Video SettingsAudio and Video GeneralAudio settings Image Settings Camera control area Camera ControlPreset function area FTP Email & FTPUrl http//Network Camera/setup/mailftp.html Motion detection Application settings Method for sending snapshot System log Viewing system parameters Calibrate MaintenanceStatus LED TroubleshootingURL commands of the Network Camera Reset and restoreMethod GET/POST Get server parameter valuesReturn Set server parameter valuesYyyy/mm/dd WirelessNetwork CameraSkip to invoke default server Available parameters on the serverBlank Group Security255.255.255.0 Blank192.168.0.99 5556 5545558 Open Live.sdp Group Wireless restartDefault Auto255.255.255.255 00000000Group IPFilter 0.0For 60Hz only 51200012200 AAC4 for computerGamr for mobile Blank Blank 514 Camera ControlScript.vssx IP addressRecall Application page CGI commandEndtime WeekdayTimemethod BegintimeAccount management Capture single snapshotPrivilege=conf System logsPost data Configuration fileUpgrade firmware Page Networking Technical specificationsMicrophone GNU General Public License GNU General Public License Page Page Page No Warranty