Intellinet Network Solutions 530361 user manual Change is recommended

Page 13

RTS Threshold: This is the minimum packet size required for an RTS

(request to send). For packets smaller than this threshold, an RTS is

not sent and the packet is transmitted directly to the wireless network.

Select a setting within a range of 0 to 2347 bytes. NOTE: A minor

change is recommended.

Fragment Threshold: This value defines the maximum size of packets;

any packet size larger than the value will be fragmented. If you’ve decreased this value and experience high packet-error rates, you can increase it again, but it will likely decrease overall network

performance. Select a setting within a range of 256 to 2346 bytes.

NOTE: A minor change is recommended.

Profile Authentication and Encryption (Security)

Authentication Type: This pull-down menu setting has to be consistent with the wireless networks that the adapter is intended to connect.

Open: No authentication is needed within the wireless network.

Shared: Only wireless devices using a shared key (WEP key identified) are allowed to connect to each other.

LEAP: This is a pre-EAP, Cisco-proprietary protocol with many of the features of EAP protocols. Cisco controls the ability of other vendors to implement this protocol, so it should be selected for use only when a limited vendor choice for client, access point and server products is not a concern. When you’ve set up LEAP authentication, you need to enter the username and password of your computer.

WPA: WPA provides a scheme of mutual authentication using either

IEEE 802.1x/Extensible Authentication Protocol (EAP) authentication

CONFIGURATION 13

Image 13
Contents Model Page FCC Certifications Reorient or relocate the receiving antennaTTE Compliance Statement FCC RF Radiation Exposure StatementEU Countries Intended for Use Table of contents XP procedure is similar for Windows 98SE/Me/2000/2003/Vista InstallationWhen the Finish screen appears, click Finish ConfigurationVista, a Found New Option RaConfig as Configuration utilityNetwork Profile Configuration Profile Configuration Change is recommended Profile Authentication and Encryption SecurityConfiguration Configuration 802.1x Setting/Certification User login to the LAN approved or deniedRadius Client Radius Server Windows802.1x Setting/CA Server Wireless Mode Select from the drop-down menu Server Name Enter the authentication server nameStatistics AdvancedTo this mode. This mode is also the default setting Show Authentication Status Dialog Select to display WMM About Wps configurationAutomatically select the AP Select to activate Switch to AP Mode to activate the SoftAP function ConfigurationSoftAP Ssid The Ssid upWireless Mode Selects the wireless mode supported by the AP Open No authentication is needed within the wireless network Security settingSoftap Access control Event log Mac tableStatistics General Specifications