Intellinet Network Solutions 530361 user manual About, Wps configuration

Page 22

•Direct Link Setup Enable: Click the check box to enable, then click

“Apply” to further configure the function (all within the Direct Link panel).

-MAC Address: Specify the MAC address of the client adapter you want to direct link to and click “Apply” to add to the DLS Status table (below).

-Timeout Value: Specify the timeout value for the direct link being set up.

about

On this screen, you can click the hyperlink for information on the wireless chipset manufacturer. Basic information about the utility (driver, EEPROM version, etc.) also displays, as do various addresses for quick reference.

NOTE: This adapter features Turbo Mode, which delivers a higher throughput than IEEE 802.11g standard (up to 54 Mbps) by compressing data and decreasing the wait time for sending data to routers or access points. Turbo Mode is enabled automatically without any configuration.

wps configuration

The adapter supports WPS (Wi-Fi Protected Setup), allowing connection to wireless APs without complicated procedures. Two WPS configuration methods are available: PBC (push-button configuration) and PIN.

WPS AP List: Wireless access points offering WPS service are shown

22CONFIGURATION

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Model Page Reorient or relocate the receiving antenna FCC CertificationsTTE Compliance Statement FCC RF Radiation Exposure StatementEU Countries Intended for Use Table of contents Installation XP procedure is similar for Windows 98SE/Me/2000/2003/VistaWhen the Finish screen appears, click Finish ConfigurationVista, a Found New RaConfig as Configuration utility OptionNetwork Profile Configuration Profile Configuration Profile Authentication and Encryption Security Change is recommendedConfiguration Configuration Radius Client Radius Server User login to the LAN approved or denied802.1x Setting/Certification Windows802.1x Setting/CA Server Statistics Server Name Enter the authentication server nameWireless Mode Select from the drop-down menu AdvancedTo this mode. This mode is also the default setting Show Authentication Status Dialog Select to display WMM Wps configuration AboutAutomatically select the AP Select to activate SoftAP ConfigurationSwitch to AP Mode to activate the SoftAP function Ssid The Ssid upWireless Mode Selects the wireless mode supported by the AP Security setting Open No authentication is needed within the wireless networkSoftap Access control Mac table Event logStatistics Specifications General
Top Page Image Contents