Intellinet Network Solutions 530361 user manual Profile Configuration

Page 12

Profile Configuration

Profile Name: Define easily recognizable profile names to identify the different networks.

SSID: The SSID (up to 32 printable ASCII characters) is the unique name identified in a WLAN. The ID prevents the unintentional merging of two co-located WLANs. If you specify an SSID for the adapter, then only the device with the same SSID can interconnect to the adapter. To add a nearby network to the profile list, pull down the menu to view all the networks that can be selected.

Power Save Mode: The two power-saving functions are available only when Network Type (see below) is set to “Infrastructure.”

•CAM (Constantly Awake Mode): With this selected, the adapter will remain in an active mode.

•PSM (Power Save Mode): Enable the adapter in the power-save mode when it is idle.

Network Type: Select from the drop-down menu.

•Infrastructure: This operation mode requires the presence of an 802.11 access point. All communication is done via the AP or router.

•Ad-Hoc:Select this mode to connect to another wireless station in the wireless LAN network without using an access point or router.

Tx Power: To lower the transmit power of the adapter to reduce the power used by the system, select a lower percentage from the drop-down menu. NOTE: A lower power level will result in lower signal strength and reduced coverage range.

12CONFIGURATION

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Model Page Reorient or relocate the receiving antenna FCC CertificationsFCC RF Radiation Exposure Statement TTE Compliance StatementEU Countries Intended for Use Table of contents Installation XP procedure is similar for Windows 98SE/Me/2000/2003/VistaConfiguration When the Finish screen appears, click FinishVista, a Found New RaConfig as Configuration utility OptionNetwork Profile Configuration Profile Configuration Profile Authentication and Encryption Security Change is recommendedConfiguration Configuration User login to the LAN approved or denied 802.1x Setting/CertificationRadius Client Radius Server Windows802.1x Setting/CA Server Server Name Enter the authentication server name Wireless Mode Select from the drop-down menuStatistics AdvancedTo this mode. This mode is also the default setting Show Authentication Status Dialog Select to display WMM Wps configuration AboutAutomatically select the AP Select to activate Configuration Switch to AP Mode to activate the SoftAP functionSoftAP Ssid The Ssid upWireless Mode Selects the wireless mode supported by the AP Security setting Open No authentication is needed within the wireless networkSoftap Access control Mac table Event logStatistics Specifications General
Top Page Image Contents