Enterasys Networks X-PeditionTM manual Node B Called Node Configuration

Answering Incoming ISDN Calls

Node B (Called Node) Configuration

The following commands add two users to validate calls made from Node A. This configuration employs the username/authentication method of mapping incoming calls.

XSR(config)#username toronto privilege 0 password cleartext z

XSR(config)#username boston privilege 0 password cleartext y

These commands add a dialer pool member and set the Central Office switch type on BRI port 1/ 0:

XSR(config)#interface bri 1/0

XSR(config-if<BRI-1/0>)#isdn switch-type basic-net3

XSR(config-if<BRI-1/0>)#dialer pool-member 22

XSR(config-if<BRI-1/0>)#no shutdown

The following commands configure Dialer inter 0 on BRI interface 1/0:

XSR(config)#interface dialer 0

XSR(config-if<D0>)encapsulation ppp

XSR(config-if<D0>)ppp authentication pap

The following commands add a dialer pool and map BRI interface 1/0 to Dialer interface 1. The dialer called command maps incoming Node A calls to Node B’s 2400 number. Optionally, you can employ the dialer caller method and specify a PPP authenticated username to map incoming calls.

XSR(config)#interface dialer 1

XSR(config-if<D1>)#no shutdown

XSR(config-if<D1>)dialer pool 22

XSR(config-if<D1>)encapsulation ppp

XSR(config-if<D1>)dialer called 2400

!dialer caller 2300

!dialer remote-name toronto

XSR(config-if<D1>)ip address 10.10.10.2 255.255.255.0

The following commands add a dialer pool and map BRI interface 1/0 to Dialer interface 2. The dialer called command maps incoming Node A calls to Node B’s 2400 number. Optionally, you can employ the dialer caller method and specify a PPP authenticated username to map incoming calls.

XSR(config)#interface dialer 2

XSR(config-if<D2>)#no shutdown

XSR(config-if<D2>)#dialer pool 22

XSR(config-if<D2>)#dialer called 2400

!dialer caller 2600

!dialer remote-name boston XSR(config-if<D2>)#encapsulation ppp XSR(config-if<D2>)#ip address 20.20.20.2 255.255.255.0

The following command shuts down the SNMP server to avoid saving extraneous messages:

XSR(config)#snmp-server disable

Node D (Calling Node) Configuration

These commands add a dialer pool member and set the Central Office switch type on BRI port 1/ 0:

XSR(config)#interface bri 1/0

XSR(config-if<BRI-1/0>)#isdn switch-type basic-net3

10-22 Configuring Dialer Services