Enterasys Networks X-PeditionTM manual Driv

System Alarms and Events

Table A-6 High Severity Alarms/Events (continued)

Module	Message	Description
T1E1	Receiver has Loss of Frame (Yellow	T1/E1 physical port is detecting an OOF alarm.
	Alarm).
T1E1	LOF alarm on receiver cleared.	T1/E1 physical port is not detecting an OOF alarm.
T1E1	Transmitting Remote Alarm (Yellow	T1/E1 physical port is transmitting a remote alarm.
	Alarm).
T1E1	Transmit Remote Alarm cleared.	T1/E1 physical port is not transmitting a remote alarm.
SYNC_	The ISR could not be connected	Driver failed to connect the ISR to the BSP, so it will not start.
DRIV
SYNC_	Init string parse failure	Driver could not parse the initialization string so it will not start.
DRIV
SYNC_	Unrecoverable error	XSR has an un-recoverable error.
DRIV
SYNC_	OS initialization failure	The operating system failed to initialize the driver properly, so the
DRIV		XSR cannot start.
SYNC_	Device not found	XSR could not be found on the PCI bus, so the driver cannot start.
DRIV
SNMP	Failed to enable SNMP server	Failure to start SNMP server due to failure in the locking mechanism
		or the message queue is full.
SNMP	Failed to disable SNMP server	Failure to start SNMP server due to failure in the locking mechanism.
PLATF	System reset from <reason>, <warmcold>	Warm or cold start occurs for the following reasons:
	start	• Default config init: dcfg
		• Crash reset: crsh
		• CLI reset: cli
		• SNMP reset: snmp
		• Bootrom reset: btrm
		• Software checksum invalid: cksm
PLATF	Failed to initialize sysLog socket	Cannot create socket for sending syslogs.
PLATF	Failed to bind to sysLog port 514	Cannot bind to port 514 for sending syslogs.
ISDN	<BRI c/p>, SPID <spid string> Registered	BRI with a North American switch type successfully registers with the
	(CES <12)	central office.
ISDN	<BRI c/p>, Unsolicited	BRI with a North American switch type registers with the central
	SME_TERM_REGISTER_ACK	office but fails.
ISDN	<BRI c/p>, Registration Failed, Cause	BRI with a North American switch type registers with the central
	<number>	office and fails. Causes include: 100 - SPID configuration error, 41 -
		Network timeout and 1 - Fit timeout

ISDN	%s Layer 2 Terminal %d is DOWN
	%s Layer 2 Terminal %d is UP

Q921 - LAP-D status, UP is normal operation. Terminal is 1 for PRI. For BRI it may be 1 or 2. 1 for ETSI and NTT. For North America 1 and 2 if two SPIDs are configured.

ISDN	%s Outgoing Call to %s %s Timed Out	For basic-NET3 BRI, XSR was unable to activate the BRI line for an
		outgoing call.
ISDN	%s Switch Offers call for BUSY channel	Error condition!
	%X

A-4 Alarms/Events, System Limits, and Standard ASCII Table