Enterasys Networks X-PeditionTM manual Numbering XSR Slots, Cards, and Ports, Supported Ports

Utilizing the Command Line Interface

Supported Ports

The XSR supports the following port types:

•Single-channel ports: Fast- and GigabitEthernet, Sync/Async serial, ATM

•Multiple-channel type ports: BRI, T1/E1

Numbering XSR Slots, Cards, and Ports

The syntax for XSR slot, card, and port numbering on the CLI, illustrated in Figure 2-2, is:

slot#/card#/port#

These parameters indicate:

•slot #: (motherboard is zero), (XSR 1800: 1/2, 3020/3150: 1/2, 3250: 0-2)

•card #: NIM card number (FastEth: 1/2, GigaEth: 1-6 from left to right)

•port #: NIM port numbers begin with zero

Figure 2-2 Slots on the XSR-3250

Slot 1 Slot 2

	XSR-3250	NIM1	NIM2			10/100/1000	10/100/1000
SECURITY ROUTERS	NIM 1	NIM 2
				Link	1000
		SYS	VPN	TX
		PWR
				COM	GBIC	ETH1	ETH2	ETH3
			COM

Slot 0 Motherboard

Slot, cards, and ports on the motherboard (Slot 0) are expressed as:

•Slot 0, Card 1 or 2, Port 1 or 2: 0/1/1-4or 1/1-4and 0/2/1-4or 2/1-4. The first 0 can be ignored

Slot, cards, and ports on the first XSR-3250 upper tray slot are expressed as:

• Slot 1, Card 1 or 2, Port 1-4: 1/1/1-4and 1/2/1-4

Slot, cards, and ports on the second XSR-3250 upper slot are expressed as:

• Slot 2, Card 1 or 2, Port 1-4: 2/1/1-4and 2/2/1-4

Setting Port Configuration Mode

The configuration mode setting for ports on the XSR is as follows:

•Single-channel ports are configured in Interface configuration mode.

•Multi-channel ports are configured in Controller configuration mode. A physical layer data stream is identified by channel using the controller command, and this channel group is then configured using the interface command.

Setting Interface Type and Numbering

XSR interface types and numbers are set as follows:

•Physical-type interface and port numbers are similar. Interface types are Serial BRI, ATM, PRI (T1/E1), or Fast/GigabitEthernet.

XSR User’s Guide 2-17