Enterasys Networks X-PeditionTM manual ETH1

System Alarms and Events

Table A-6 High Severity Alarms/Events (continued)

Module Message Description

ISDN	Incoming Call <BRI Serial card/
	port:channel> Connected to <calling no.>
	Unknown Call

An incoming call connected for test purposes will be disconnected within 30 seconds.

ISDN	North American BRI Interface %d requires	Configuration error.
	SPID configuration
ISDN	Call <BRI Serial card/port:channel>	A test call is placed from the console.
	Connected to <called_no.> Outgoing test
	CALL

ISDN	Call <BRI Serial card/port:channel>
	Disconnected from <number> <Outgoing
	test CALL Unknown Call> Cause <passed
	from central office>

A test call is disconnected due to the standard ISDN cause. E.g. 16: normal clearing, 18: user does not answer.

ISDN	No Channel Available <destination name>	ISDN line was over subscribed.
ISDN	_FILE _LINE Out of memory	Unable to allocate memory.
ISDN	ISDN panic!!	Unable to create ISDN object.
ISDN	_FILE _LINE Out of memory	Unable to allocate memory.
ISDN	_FILE _LINE Out of memory	Unable to allocate memory.
ISDN	_FILE _LINE unexpected value	Unexpected message received.
ISDN	Interface BRI, changed state to up	Port has changed to Up state.
ISDN	Interface BRI, changed state to down	Port has changed to Down state.
FR	Serial a/b:d.e, started	Output from the no shutdown command.
FR	Serial a/b:d.e, shutting down	The interface has been manually shut down.
FR	Serial a/b:d.e, station UP, DLCI nnnn	The network reports the station is up.
FR	Serial a/b:d.e, station DOWN, DLCI nnnn	The network reports the station is up.

FR	Serial a/b:d cannot establish LMI, port is
	down

The network has not been responding for 5 minutes. You should check the connection.

FR	Serial	a/b:d LMI - port DOWN	The LMI is reporting the port is Down.
FR	Serial	a/b:d LMI - port UP	The network is reporting the port is Up.

FR	Serial a/b:d.e Config Error Aggregate CIR
	nnnn greater than measured speed nnn -
	CIR Assist is DISABLED

The total configured CIR exceeds the speed of the link and cannot guarantee CIR. Assist will not be operational.

ETH1_	The device is stuck in reset	The FastEthernet 2 chip on the motherboard has severe problems -
DRIV		it cannot come out of reset and the FastEthernet 2 driver/interface
		cannot be started. The most likely cause is a hardware failure. When
		this alarm occurs, FastEthernet Interface 2 is not available.
ETH1_	The device TX/RX is stuck in reset	The FastEthernet 2 chip on the motherboard has severe problems -
DRIV		either the transmitter or receiver cannot come out of reset and the
		FastEthernet 2 driver/interface cannot be started. The most likely
		cause of this alarm is a hardware failure, rendering FastEthernet port
		2 unavailable.

XSR User’s Guide A-5