Configuring DoD/BoD

XSR(config)#interface dialer 1 XSR(config-if<D1>)#encapsulation ppp XSR(config-if<D1>)#ip address 172.22.85.2

XSR(config-if<D1>)#ppp pap sent-username XSR-andover password secret 0 dolly XSR(config-if<D1>)#dialer pool 1

XSR(config-if<D1>)#dialer string 47410 XSR(config-if<D1>)#dialer-group 1

+Defines interesting packets to trigger dial out

XSR(config-if<D1>)#dialer idle-timeout 20

+Terminates call to Toronto if the line is idle for 20 seconds

XSR(config-if<D1>)#no shutdown

The following commands add a dial pool member and set the Central Office switch type on BRI interface 1/0:

XSR(config)#interface bri 1/0

XSR(config-if<BRI-1/0>)#isdn switch-type basic-net3

XSR(config-if<BRI-1/0>)#dialer pool-member 1

XSR(config-if<BRI-1/0>)#no shutdown

The following command maps ACL 101 to dialer group 1:

XSR(config)#dialer-list 1 protocol ip list 101

The following command defines interesting packets for the dial out trigger by configuring access list 101 to pass all Type 8 source and destination ICMP traffic up to 20 idle seconds:

XSR(config)#access-list 101 permit icmp any any 8

PPP Point-to-Multipoint Configurations

The following topology can be used for Dial on Demand applications only; it cannot be used for Dialed Backup applications. Refer to Figure 10-13.

Figure 10-13 PPP Point-to-Multipoint Topology

 

 

172.22.80.4

 

XSR-Toronto

 

 

172.22.85.1

Switched

Switched

Switched

line

line

line

172.22.85.2

172.22.85.3

172.22.85.4

XSR-Andover

XSR-Boston

XSR-Buffalo

172.22.95.2 172.22.96.2 172.22.97.2

10-28 Configuring Dialer Services

Page 250
Image 250
Enterasys Networks X-PeditionTM manual PPP Point-to-Multipoint Configurations, PPP Point-to-Multipoint Topology